This guide covers assembly of the Premier 29 in. Old Time Truck Spinner. Connect the struts, add the spinner wheels and place the spinner on its support pole.

Applies to: 29 in. Old Time Truck Spinner. See the 1 products this guide covers.

Assembly

Step 1: Connect the strut assemblies

The Strut Assembly of your Old Time Truck spinner is shipped in three sections. Connect Center Rods of the Rear Strut Assembly and the Front Strut Assembly to the Center Rod of the Center Strut Assembly as shown. (diagram A)

The Rear Strut Assembly and Front Strut Assembly each connect into the Center Strut Assembly. The long vertical rod on the Center Strut Assembly stays below the center connection.

Old Time Truck Spinner rear, center and front strut assemblies
Diagram A: Connect the strut assemblies.

Step 2: Insert the completed strut assembly

Open Velcro straps and insert completed Strut Assembly into bottom of Old Time Truck Body Sleeve as shown. Reclose Velcro straps. (diagram B)

The completed Strut Assembly goes up into the bottom of the Old Time Truck Body Sleeve. Line up the assembly under the body before reclosing the Velcro straps.

Old Time Truck Spinner body sleeve with completed strut assembly below
Diagram B: Insert the completed strut assembly into the body sleeve.

Step 3: Add the rear spinner axle

Take one of the Spinner Axles and slide it onto the Rear Strut Assembly at back of Old Time Truck Body. Tighten the knob on the "T" Joint to hold the Axles to the Struts. (diagram C)

Slide the Spinner Axle onto the Strut Assembly first, then tighten the knob on the "T" Joint. The "T" Joint sits below the truck body with the Spinner Axle running through it.

Old Time Truck Spinner rear spinner axle and T joint under the body
Diagram C: Slide on the rear spinner axle and tighten the T joint.

Step 4: Install the rear spinner wheels

Take one of the four Spinner Wheels and slide it onto one of the two Spinner Axles. Slide second Spinner Wheel onto Spinner Axle. (Note: Spinner Wheels on same side of Old Time Truck should spin in same direction and Spinner Wheels on same axle should spin in opposite directions. Before putting second Axle Cap into place, make sure wheels spin as shown in diagrams D and E.) Pound second Axle Cap onto uncapped end of Spinner Axle using a mallet or piece of wood. (diagram D)

The Spinner Wheels sit on opposite ends of the same Spinner Axle. After both wheels are on the axle, the Axle Cap goes onto the uncapped end.

Old Time Truck Spinner wheels on an axle with an axle cap
Diagram D: Install the spinner wheels and axle cap.

Step 5: Assemble the front spinner

Repeat Step 4 using second Spinner Axle and the two remaining Spinner Wheels to assemble front Spinner.

Use the second Spinner Axle at the front of the truck body. The two remaining Spinner Wheels make the front spinner.

Step 6: Install the support pole and ground stake

Pound Ground Stake into ground and insert non-ferruled end of Support Pole into Ground Stake. Insert Upper Pole Section of completed Old Time Truck Spinner into ferrule on top of Support Pole. (diagram E)

The Support Pole stands in the Ground Stake, with the ferrule at the top. The completed Old Time Truck Spinner lowers into that ferrule.

Old Time Truck Spinner on support pole and ground stake
Diagram E: Place the spinner on the support pole.

Care note

Although your Accent Old Time Truck Spinner is constructed with UV resistant SunTex™ fabric, it is recommended that you take it inside during storms and harsh weather to preserve its durability.

Products this guide covers

Download the original manual

Old Time Truck Spinner Assembly Instructions (PDF)

Latest Stories

This section doesn’t currently include any content. Add content to this section using the sidebar.