This guide covers assembly and basic flight instructions for Premier 56 in. Rokkaku kites. It applies to the Rainbow Bubbles, Rainbow Orbit and Sea Turtles designs.

Applies to: 56 in. Rokkaku Kite - Rainbow Bubbles, Rainbow Orbit and Sea Turtles. See the 3 products this guide covers.

Specs

Model Size Wind range Fabric Frame Line
56 in. Rokkaku Kite 46 x 56 in. / 120 x 142 cm. 5 ~ 18 mph Ripstop Polyester Tubular Fiberglass Includes 300 ft. 50 lb. Test Line & Winder

Assembly

Step 1: Install the center spine

Join center spine together at ferrule. Slide center spine through bottom Velcro sleeve pocket, then insert top of spine into top pocket and finally close Velcro spine pocket. Velcro pocket should be pulled up tight to tension sail. (Diagram A)

The center spine runs vertically down the middle of the kite, with the ferrule near the center. The bottom Velcro sleeve pocket is at the lower end of the spine; after the top is in the top pocket, pull the sleeve upward before closing it.

56 in. Rokkaku center spine, Velcro sleeve pocket, top pocket and strut tie down points
Diagrams A and B: Center spine and strut tie down points.

Step 2: Tie the struts to the sail

Tie struts to sail at tie down points. (Diagram B)

The tie down points are where the horizontal cross struts cross the center spine. The spine is positioned on top of the horizontal cross struts.

Step 3: Tension the bow strings

Before flying, cross struts must be bowed approximately 7” by tensioning the Bow Strings.To Tension:Hold the tensioner with the left hand and pull the line through the tensioner with your right hand as shown on the diagram until the kite starts to bow. Bow distance should be about 7”. Once in place, make sure line is “locked” into tensioner slot.To De-Tension:Hold the tensioner with your left hand and one of the lines on the right side of the kite with your right hand and simply slide the tensioner back until the bow starts to go straight and the bow line go slack.

The tensioner is on the bow line near the cross strut, and the line locks into the tensioner slot. When set, the cross struts are bowed and the bow distance is about 7”.

56 in. Rokkaku bow string tensioner slot with cross struts bowed about 7 inches
Diagram C: Bow string tensioning and tensioner slot.

Flight instructions

Launch the kite

Tie the end of the flying line to the bridle tow loop. Have a friend stand about 75 ft downwind from you and hold the kite with its nose pointed towards the sky. As the wind catches the kite, signal your friend to release it while you bring in the line with long steady pulls. As the kite flies upward, slowly let out more line.

The flying line attaches to the tow loop on the bridle above the kite, and the helper holds the kite downwind for launch.

56 in. Rokkaku flight setup with wind direction and bridle tow loop
Flight instructions: Tie the flying line to the tow loop and launch downwind.

Products this guide covers

Download the original manual

56 in. Rokkaku Kite Assembly Instructions (PDF)

Latest Stories

This section doesn’t currently include any content. Add content to this section using the sidebar.