This guide covers assembly for the Premier Large WhirliGig Spinner themed for Day of the Dead Woman / Dia de los Muertos Mujer. Follow the steps to install the axle, spinner sets, support pole and ground stake.
Applies to: WhirliGig Spinner - Day of the Dead Woman. See the 1 products this guide covers.
Assembly
Step 1: Install the spinner axle
Slide the long end of the Spinner Axle through the Axle Opening in the WhirliGig Body on the same side as the Velcro Tab. Open the Velcro Tab and guide the Axle through the Hub inside the WhirliGig Body. Slide the Axle as far as possible until the first Stop reaches the Hub. This should make the ends of the Axle equally far from the WhirliGig Body. (Diagram A)
The Axle Opening is beside the Velcro Tab, and the axle passes through the WhirliGig Body and into the Hub inside. When it is positioned as shown, the Spinner Axle extends out both sides of the WhirliGig Body.
Tip: Make sure that the Stops are on the same side of the Hub as the longer end of the Axle Sleeve.

Step 2: Add the spinner sets
Set the Spacer, two Washers and one spinner set aside. Slide one Washer onto the side of the Axle with the Stops. Slide one set of arms onto the Axle followed by the remaining Washer. Carefully pound the End Cap onto the Axle. Repeat with the remaining parts on the other side of the Axle, making sure to place the Spacer closest to the WhirliGig Body. (Diagrams B & C)
On the side of the Axle with the Stops, the order shown is Washer, Spinner Set, Washer, then End Cap. On the other side of the Axle, the Spacer sits closest to the WhirliGig Body before the remaining spinner parts are installed.


Step 3: Attach the support pole
Slide the narrow, plastic tipped end of the Support Pole into the Star Lock Hub. Push down on the hub until the Support Pole locks into place and can not be removed. (Diagram C)
The Plastic Tip is at the narrow end of the Support Pole and points up toward the Star Lock Hub. Push Star Lock Hub firmly onto Plastic Tip of Support Pole.
Tip: To make insertion process easier, place bottom of Support Pole on a hard, flat surface and push down on Star Lock Hub.
Step 4: Place the spinner in the ground stake
Drive Ground Stake into ground and insert the Support Pole of assembled WhirliGig Spinner into the ground stake. (Diagram D)
The Ground Stake is in the ground with the Support Pole inserted straight down into it. The assembled WhirliGig Spinner stands above the stake on the Support Pole.

Care note
Please note: It is recommended that you take your WhirliGig Spinner inside during storms and harsh weather to preserve its durability.
Products this guide covers
Download the original manual
Day of the Dead WhirliGig Spinner Assembly Instructions (PDF)


WhirliGig Spinner - Day of the Dead Woman
Share:
Crayon Kite Assembly Instructions
Dimension X Assembly Instructions