This guide shows how to assemble and fly Premier Easy Flyer kites, the single-line delta kites with banner tails. It covers all three sizes: Easy Flyer, Large and Jumbo.

Applies to: Premier Easy Flyer kites (Regular, Large, Jumbo). See the 48 products this guide covers.

Assembly

Step 1: Unroll kite

Unroll kite.

Take the kite out of the bag and unroll the sail fully on a clean, flat surface. Smooth out any folds so you can clearly see the body and the long banner tail.

Step 2: Identify the strut

Identify struts (Diagram A).

Locate the single Cross Strut shown in Diagram A. It runs across the back of the kite, from one leading edge to the other.

Easy Flyer cross strut
Diagram A: Cross Strut.

Step 3: Install the Cross Strut

Insert the Cross Strut into the Cross Strut Pockets at the leading edge of the kite (Diagram B).

Turn the kite so the back of the kite faces up, as shown in Diagram B. Slide one end of the Cross Strut into the Cross Strut Pocket on one leading edge, then guide the other end into the matching pocket on the other leading edge. The strut should sit straight across the back of the kite with each end fully seated in its pocket.

Tip: Start one end in a pocket first, then gently bend the rod just enough to reach the other pocket—don’t force it through the fabric.

Back of Easy Flyer showing cross strut inserted into cross strut pockets
Diagram B: Back of kite — insert the cross strut into the cross strut pockets.

Step 4: Attach the flying line

Attach your line to the tow point (Diagram C).

Flip the kite to the front side. Tie your flying line securely to the tow point on the keel, as labeled in Diagram C. Make sure the knot is tight so the line cannot slip.

Front of Easy Flyer showing keel and tow point for attaching flying line
Diagram C: Front of kite — tow point on the keel.

Ready to fly

Your kite is now ready to fly!

Flying instructions

Step 1: Connect the line

Attach flying line to Tow Loop.

Tie the end of your flying line to the tow point on the kite’s keel (Diagram C). Give a light pull to confirm the connection is secure.

Step 2: Position your helper

Have a friend stand about 75 ft. downwind from you and hold the kite with its Leading Edge pointed towards the sky.

Walk back, letting out line, while your friend holds the kite. The wind should be at your back, and the kite’s top (leading edge) should face upward.

Tip: Downwind means the wind is blowing from you toward your helper.

Step 3: Launch on your signal

As the wind catches the kite, signal your friend to release it while you bring in the line with long steady pulls.

Watch for the sail to fill. When it does, have your friend let go and pull in smoothly to build lift.

Tip: Use smooth, even pulls rather than quick jerks to keep the kite stable.

Step 4: Let the kite climb

Slowly let out more line as the kite flies upward.

Let out line slowly while keeping slight tension so the kite continues to rise. If the kite stalls, take a few steady pulls to regain lift before letting out more line.

Before you fly

  • Recommended line: 30 lb. test line. Each size comes with its own line; see the size table below.
  • Note: Wind conditions aloft may vary considerably from those found near ground level.

Easy Flyer sizes and specs

Size Dimensions Wind range Line included
Easy Flyer (Regular) 30 x 90 in. (76 x 229 cm) 5–18 mph 300 ft. of 20 lb test line
Large Easy Flyer 46 x 90 in. (117 x 229 cm) 5–18 mph 300 ft. of 30 lb test line
Jumbo Easy Flyer 64 x 165 in. (163 x 420 cm) 4–20 mph 300 ft. of 50 lb test line and a winder

Beaufort scale reference

Best wind for Easy Flyer kites: 5–18 mph.

Beaufort category Description (from chart) Wind (mph)
Calm smoke rises vertically 0
Light Air direction of wind shown by smoke, but not by wind vanes 1–3
Light Breeze wind felt on face, leaves rustle, ordinary vane moves 4–7
Gentle Breeze leaves and small twigs in constant motion; wind extends light flag 8–12
Moderate Breeze raises dust and loose paper; small branches move 13–18
Fresh Breeze small trees & leaves begin to sway; crested wavelets form on inland water 19–24
Strong Breeze large branches in motion; utility wire whistle; windows rattle 25–30
Beaufort wind scale chart showing the Easy Flyer kite's best wind range, 5 to 18 mph
Beaufort scale: Optimum wind conditions for Easy Flyers.

Products this guide covers

Download the original manual

Easy Flyer Kite Assembly Instructions (PDF)

Latest Stories

This section doesn’t currently include any content. Add content to this section using the sidebar.