This guide covers assembly for the Premier Zombie Cruiser Spinner and 17 in. Golf Cart Spinner. It shows how to install the support pole, axles, spinner wheels, and ground stake.

Applies to: Zombie Cruiser Spinner and 17 in. Golf Cart Spinner - Blue. See the 2 products this guide covers.

Product sizes

Product Size (W x L)
Zombie Cruiser Spinner 25.5 in. x 16 in.
17 in. Golf Cart Spinner - Blue 17 in. x 15 in.

Assembly

Step 1: Open the bottom seam

Remove your spinner from the package. Open the Velcro seam along the bottom of the Cruiser or Golf Cart.

The Velcro seam is along the bottom of the vehicle body. Opening it gives you access to the internal Star Lock Hub for the support pole.

Step 2: Install the upper support pole

Slide the narrow, plastic-tipped end of the Upper Support Pole into the Star Lock Hub. Push down on the hub until the Support Pole locks into place and cannot be removed. Close Velcro seam. Completed internal Strut Assembly should match Diagram A.

Insert the plastic tip of the Upper Support Pole upward into the Star Lock Hub. When the internal assembly is in place, the Upper Support Pole extends down from the center of the spinner body.

Tip: To make insertion process easier, place bottom of Support Pole on a hard, flat surface and push down on Star Lock Hub.

Golf Cart and Zombie Cruiser spinner Diagram A with upper support pole entering star lock hub
A. Star Lock Hub and Upper Support Pole.

Step 3: Attach the spinner axles

Slide the Spinner Axles onto the Wheel Strut Assemblies. Tighten knobs on the “T” Joints to hold the Axles to the Struts. (Diagram B)

Each Spinner Axle is held at a Wheel Strut Assembly by a “T” Joint. The axle sits horizontally once it is on the strut.

Golf Cart and Zombie Cruiser spinner Diagram B showing spinner axle and T Joint
B. Spinner Axle on Wheel Strut Assembly.

Step 4: Add the spinner wheels

Take one of the four Spinner Wheels and slide it onto one of the two Spinner Axles. Slide second Spinner Wheel onto Spinner Axle. Note: Spinner Wheels on same side of the spinner should spin in same direction and Spinner Wheels on same axle should spin in opposite directions. Before putting second Axle Cap into place, make sure wheels spin as shown in diagrams C and D. Pound second Axle Cap onto uncapped end of Spinner Axle using a mallet or piece of wood. (Diagram C)

A Spinner Wheel slides onto the Spinner Axle, and the Axle Cap goes onto the uncapped end after the wheels are positioned. The wheels on the same axle turn in opposite directions.

Golf Cart and Zombie Cruiser spinner Diagram C with spinner wheels on the axle
C. Spinner Wheels and Axle Cap.

Step 5: Set the spinner on the ground stake

Drive Ground Stake into ground and insert the non-ferruled end of the Lower Support Pole into the Ground Stake. Insert Upper Pole of assembled spinner into the ferrule. (Diagram D)

The non-ferruled end of the Lower Support Pole goes down into the Ground Stake. The ferrule stays above it and receives the Upper Support Pole from the assembled spinner.

Golf Cart and Zombie Cruiser spinner Diagram D on lower support pole and ground stake
D. Support poles, ferrule, and Ground Stake.

Weather note

It is recommended that you take your Zombie Cruiser Spinner or Golf Cart Spinner inside during storms and harsh weather to preserve its durability.

Products this guide covers

Download the original manuals

Premier prints a manual for each design; the steps are the same apart from the differences noted above.

Latest Stories

This section doesn’t currently include any content. Add content to this section using the sidebar.