This guide covers the basic setup and launch instructions for Premier Gyro Delta kites. It applies to the Rainbow, Patriotic and Rainbow Orbit designs. Recommended age: 5+.
Applies to: Gyro Delta Kite - Patriotic, Rainbow and Rainbow Orbit. See the 3 products this guide covers.
Specifications
| Models | Size | Wind range | Line | Frame | Spin sock |
|---|---|---|---|---|---|
| Patriotic, Rainbow, Rainbow Orbit | 58 x 44 in. / 147 x 112 cm. | 6 ~ 18 mph | Includes 300 ft. of 50 lb. Test Line & Winder | Fiberglass | 6 x 31 in. / 15 x 79 cm. |
Get ready
Step 1: Check the leading edge struts
Make sure the leading edge struts extend down to the end of the sleeves.
The back of the kite is the side with the spine and cross strut labels. The leading edge strut sits inside the sleeve along the outer edge, with the end of sleeve marked near the lower corner.

Step 2: Insert the cross strut
Insert the cross strut into pockets.
The cross strut runs side to side across the back of the kite. Each end goes into a pocket near the leading edge.
Step 3: Attach the flying line
Turn your kite to the front and locate the keel. Attach the flying line to the bridle loop on the front of the keel.
On the front of the kite, the keel is at the center and the bridle loop is at the tow point. Attach the flying line to that bridle loop.
To fly
Step 1: Launch the kite
Have a friend stand about 75 feet downwind from you and hold the kite with its nose pointed towards the sky. As the wind catches the kite, signal your friend to release it while you steadily pull in line until the kite is aloft. As the kite flies upward, slowly release more line.
Have your friend stand about 75 feet downwind from you. Keep the nose pointed toward the sky for the launch, then let out more line only after the kite is flying upward.


Gyro Delta Kite - Patriotic
Gyro Delta Kite - Rainbow
Gyro Delta Kite - Rainbow Orbit
Share:
Googleflex Assembly Instructions
Hatteras Lighthouse Spinner Assembly Instructions