This guide covers assembly of the Hatteras Lighthouse Spinner. It follows the manufacturer’s steps for the internal strut, support pole, spinner axle, spinner wheels and ground stake.
Applies to: Hatteras Lighthouse Spinner. See the 1 products this guide covers.
Specifications
| Product | Size (W x L) |
|---|---|
| Hatteras Lighthouse Spinner | 12.25 in. x 33 in. |
Internal strut assembly

Completed Internal Strut Assembly. Make sure all parts connect as shown.
Assembly
Step 1: Connect the support pole
The Strut Assembly of your Lighthouse spinner is shipped in two sections. Connect support pole (with ferrule end up) to internal strut assembly through small opening in the bottom of the Lighthouse body as shown. (diagram A)
The small opening is in the bottom of the Lighthouse body. Keep the ferrule end of the Support Pole facing up toward the Internal Strut Assembly as the pole passes through that opening.

Step 2: Attach the spinner axle
Take the Spinner Axle and insert it through the opening so that the vertical portion of “T” Joint aligns with the vertical strut of the Internal Strut Assembly at the top of the Lighthouse body. (diagram B) Slide the vertical portion of “T” Joint onto the vertical strut of the Internal Strut Assembly. Tighten the knob on the “T” Joint to hold the Axle to the Strut. (diagram C)
Follow the order called out on the diagrams: first put the Spinner Axle through the opening and align the “T” Joint with the Strut Assembly, second slide the Spinner Axle onto the strut assembly, and third tighten the knob on the “T” Joint. When this step is in place, the Spinner Axle runs side to side at the top of the Lighthouse body.

Step 3: Install the spinner wheels
Take one of the two Spinner Wheels and slide it onto one of the Spinner Axles. Slide second Spinner Wheel onto Spinner Axle. (Note: Spinner Wheels on same axle should spin in opposite directions. Before putting Axle Caps into place, make sure wheels spin as shown in diagram D.) Pound Axle Cap onto uncapped end of Spinner Axle using a mallet or piece of wood. (diagram D)
Both Spinner Wheels sit on the same axle at the top of the lighthouse. The Axle Cap goes on the uncapped end after the Spinner Wheels are in place.

Step 4: Set the spinner on the ground stake
Pound Ground Stake into ground and insert non-ferruled end of Support Pole into Ground Stake. (diagram E)
The Ground Stake is driven into the ground, with the Support Pole above it. Use the end of the Support Pole without the ferrule for the end that goes into the Ground Stake.
Care and storage
Please note: Although your Lighthouse Spinner is constructed with UV resistant SunTex™ fabric, it is recommended that you take it inside during storms and harsh weather to preserve its durability.


Hatteras Lighthouse Spinner
Share:
Gyro Delta Kite Assembly Instructions
High Wheel Bike Spinner Assembly Instructions