This guide covers the assembly steps for Premier Large WhirliGig Spinners. It shows how to set the axle, add the spinner sets, attach the support pole, and place the spinner in the ground stake.
Applies to: Premier WhirliGig Spinner designs on this page. See the 18 products this guide covers.
Assembly
Step 1: Position the spinner axle
Loosen the Thumb Screw on the Main Frame and slide the Spinner Axle as far as possible through the Frame. This should make the ends of the Axle equally far from the WhirliGig Body. Tighten Thumb Screw. (Diagram A)
When the axle is positioned correctly, the two ends of the Spinner Axle extend an equal length on each side of the WhirliGig Body. The Thumb Screw and the Stops sit on the same side of the Main Frame.
Tip: Make sure Thumb Screw and Stops are on the same side of the Main Frame.

Step 2: Add the spinner sets
Set the Spacer, two Washers and one spinner set aside. Slide one Washer onto the side of the Axle with the Stops. Decide which way you want the arms or wings to face and slide one set onto the Axle followed by the remaining Washer. Carefully pound the End Cap onto the Axle. Repeat with the remaining parts on the other side of the Axle, making sure to place the Spacer closest to the WhirliGig Body. (Diagrams B & C)
Build the side with the Stops first, using a Washer, the Spinner Set, another Washer, and the End Cap. On the other side of the axle, the Spacer goes between the WhirliGig Body and the Spinner Set, closest to the WhirliGig Body.


Step 3: Attach the support pole
Slide the narrow, plastic tipped end of the Support Pole into the Star Lock Hub. Push down on the hub until the Support Pole locks into place and cannot be removed. (Diagram C)
The Plastic Tip is the narrow end of the Support Pole. Line it up with the Star Lock Hub and push the hub down onto that tip.
Tip: To make insertion process easier, place bottom of Support Pole on a hard, flat surface and push down on Star Lock Hub.
Step 4: Install the spinner in the ground stake
Drive Ground Stake into ground and insert the Support Pole of assembled WhirliGig Spinner into the ground stake. (Diagram D)
The assembled spinner sits above the Ground Stake with the Support Pole going down into the stake. The Ground Stake stays in the ground while the Support Pole holds the WhirliGig Spinner upright.

Care and weather
Please note: It is recommended that you take your WhirliGig Spinner inside during storms and harsh weather to preserve its durability.
Products this guide covers
15 in. WhirliGig Spinner - Party Cups
18 in. WhirliGig Spinner - Crab
19 in. WhirliGig Spinner - Red Dragon
21 in. WhirliGig Spinner - Orange Owl
23 in. WhirliGig Spinner - Brown Pelican
24 in. WhirliGig Spinner - Fisherman
25 in. WhirliGig Spinner - Blue Jay
28 in. WhirliGig Spinner - Victorian Swimmer
29 in. WhirliGig Spinner - Mermaid
29 in. WhirliGig Spinner - Road Runner
29 in. WhirliGig Spinner - Uncle Sam
WhirliGig Spinner - 24 in. Cactus
WhirliGig Spinner - Bass
WhirliGig Spinner - Sea Turtle
18 in. WhirliGig Spinner - Island Parrot
25 in. WhirliGig Spinner - Patriotic Eagle
28 in. WhirliGig Spinner - Loon
WhirliGig Spinner - 18 in. Maryland Crab



Share:
Large Triple Spinner Assembly Instructions
L.E.D. Tail Light Instructions