This guide covers assembly of the Premier Large Triple Spinner. It applies to the Large Patriotic Triple Spinner and Large Rainbow Triple Spinner.

Applies to: Large Patriotic Triple Spinner and Large Rainbow Triple Spinner. See the 2 products this guide covers.

Specs

Products Spinner platform Size
Large Patriotic Triple Spinner; Large Rainbow Triple Spinner Triple Spinner 48 in. x 46 in.

Assembly

Step 1: Hook the rear sail spreader rod

Hook ends of Rear Sail Spreader Rod into loops at rear edges of Sail. (diagram A)

The rear sail spreader rod runs along the rear edge of the sail. There is one loop at each rear edge of the sail for the rod ends.

Large Triple Spinner sail with rear sail spreader rod and horizontal support rods
Diagram A: Rear sail spreader rod and horizontal support rods.

Step 2: Join the horizontal support rods

Slide ferruled end of Rear Horizontal Support Rod through Reinforced Hole at rear of Sail and fit into ferrule at rear of Front Horizontal Support Rod. (diagram A) Hook Arrow Nock on rear end of Rear Horizontal Support Rod onto Rear Sail Spreader Rod. Rear Sail Spreader Rod should snap securely into Arrow Nock. (diagram B)

The rear horizontal support rod enters through the reinforced hole at the rear of the sail. Its ferruled end points toward the front horizontal support rod, while the arrow nock stays at the rear end for the rear sail spreader rod.

Large Triple Spinner arrow nock hooked onto the rear sail spreader rod
Diagram B: Fit ferrules together and hook the arrow nock.

Step 3: Install the three spinners

Slide Spinner onto Front Horizontal Support Rod up to Fixed Stopper. Slide Stopper onto Front Horizontal Support Rod and align with mark closest to Spinner. Tighten into place with enclosed small Allen Wrench. Repeat for second and third Spinners. After assembling Spinners insert End Cap over front end of Front Horizontal Support Rod. (diagram C)

Each spinner sits on the front horizontal support rod between stoppers. The stopper alignment marks are on the rod ahead of the spinner, and the end cap covers the front end of the rod when all three spinners are in place.

Tip: A small gap of about 1/16" should exist between Spinner and Stoppers to each side. Attaching Spinner flush against Stoppers may impede Spinner's ability to spin. Occasional lubrication of Hub and Blade Hubs will increase spinning efficiency. Use any light grease or machine oil.

Large Triple Spinner stopper aligned with marks on the front horizontal support rod
Diagram C: Stopper alignment marks, end cap, and Allen wrench.

Step 5: Install the mast pole sections

Pound Ground Stake into ground and insert non-ferruled end of Mast Pole Section. Insert non-ferruled end of second Mast Pole Section into ferrule on top of first Mast Pole Section. Insert bottom of Mast Segment of completed Large Triple Spinner into ferrule on top of second Mast Pole Section. (diagram D)

The two mast pole sections stack above the ground stake, with the ferrule shown at the connection between them. The completed large triple spinner sits above the second mast pole section.

Tip: To prolong life of Triple Spinner, never leave out in storms, bad weather, or in winds of over 20mph.

Large Triple Spinner on mast pole sections above the ground stake
Diagram D: Completed spinner on mast pole sections and ground stake.

Products this guide covers

Download the original manual

Large Triple Spinner Assembly Instructions (PDF)

Latest Stories

This section doesn’t currently include any content. Add content to this section using the sidebar.