This guide covers assembly of the Premier Lighthouse Spinner - Hatteras. It shows how to place the spinner assembly on the spinner axle, secure it to the hub, and connect the support poles.

Applies to: Lighthouse Spinner - Hatteras, Petite, 12 in. x 21 in. See the 1 products this guide covers.

Assembly instructions

Step 1: Remove the cotter pin, bushing, and washer

Remove Cotter Pin and slide Bushing and one Nylon Washer from the Spinner Axle.

The cotter pin, bushing, and nylon washer are used again in later steps. The spinner axle is the horizontal axle that passes through the spinner assembly and hub.

Step 2: Slide on the spinner assembly

Slide Spinner Assembly onto the Spinner Axle and replace the Nylon Washer and Bushing.

The spinner assembly sits on the spinner axle between the nylon washers. The bushing goes back on outside the nylon washer.

Step 3: Insert the spinner axle through the hub

Slide Spinner Axle through the hole in the Hub.

The hub is mounted on the support pole. Slide the Spinner Axle through the hole in the Hub.

Step 4: Secure the axle with the cotter pin

Slide the Cotter Pin through the hole in the Spinner Axle and bend the ends outward to secure in place.

The cotter pin goes through the hole at the end of the spinner axle. Once the ends are bent outward, the axle is held in place at the hub.

Step 5: Connect the support poles

Connect Upper Support Pole with Lower Support Pole and insert into the ground.

The ferrule joins the upper support pole to the lower support pole. Insert the lower support pole into the ground so the lighthouse stands upright.

Mounting note

Compatible with Premier's 6 mm Deck Mount (sold separately).

Products this guide covers

Download the original manual

Lighthouse Spinner - Hatteras Assembly Instructions (PDF)

Latest Stories

This section doesn’t currently include any content. Add content to this section using the sidebar.