This guide covers assembly for the Premier North American Cardinal Spinner. Follow the steps to assemble the body struts, attach the wing fins, and mount the spinner on the support pole.

Applies to: 37 in. North American Cardinal Spinner. See the 1 products this guide covers.

Assembly

Step 1: Assemble the body struts

Start by removing any Small Fiberglass Rods taped to strut system. Slide Tail Rod in Back Body Half into “T” Joint. Slide the shorter of the two Small Fiberglass Rods into opening of vertical pocket in Back Body Half. Fit uncapped end into the vertical section of the “T” Joint and capped end into bottom of pocket. Slide the remaining Fiberglass Rod into the Velcro opening at the top of the head. Fit uncapped end into the vertical section of the “T” Joint and reclose Velcro opening. The completed Strut Assembly should match Diagram A.

The front body half, back body half, Wing Hub, Tail Rod, “T” Joint, and Small Fiberglass Rods are labeled in the assembly drawing. When finished, the Tail Rod from the back body half is seated in the “T” Joint, with one Small Fiberglass Rod in the head and the other in the back body half.

North American Cardinal Spinner strut, wing fin, stake, support pole and ferrule assembly diagrams
Diagrams A-D: Strut assembly, wing fin placement, and support pole setup.

Step 2: Attach the wing fins

Attach Wing Fins to Wing Hub. Please note that Wing Fins are inserted at an offset pattern. Make sure Wing Fins are fully inserted into hub holes. You will hear a “click” sound when the pins are in all the way. (Diagram B & C)

The Wing Fin Pin goes into a Hub Hole on the Wing Hub. The correct assembly uses the offset pattern marked in Diagram B; Diagram C is marked “Wrong Way!!”

Tip: If you make a mistake in the placement of the Wing Fins (i.e. backward, wrong color sequence etc.), you can remove them by carefully inserting a small flat end screwdriver between the base of the Wing Fin Pin and the hub and pushing it up and out.

Step 3: Set the spinner on the support pole

Drive Ground Stake into ground. Slide Support Pole into Ground Stake. Slide Main Hub Assembly with Garden Spinner over Support Pole Ferrule. If you desire extra height, add the extra ground shaft included in this package. (Diagram D)

The Ground Stake sits in the ground with the Support Pole above it. The Support Pole Ferrule is at the top of the pole where the Main Hub Assembly with the Garden Spinner slides on.

Care note

Although your Garden Spinner is constructed with UV resistant SunTex™ fabric, to preserve its durability, we recommend taking the Spinner inside during harsh weather or when not in use.

Products this guide covers

Download the original manual

North American Cardinal Spinner Assembly Instructions (PDF)

Latest Stories

This section doesn’t currently include any content. Add content to this section using the sidebar.