This guide covers assembling the Solar Flower - Rose solar floral stake. It shows how to install the hub, add the large, medium, and small petals, and place the finished pole in the ground shaft.

Applies to: Solar Flower - Rose. See the 1 products this guide covers.

Assembly

Step 1: Install the hub

Drop hub with drilled holes into upper pole shaft. Secure top with end cap.

The hub is the black bowl-shaped piece with rows of drilled holes. Drop it into the upper pole shaft as shown, then place the end cap on top.

Solar Flower - Rose hub dropped into upper pole shaft and secured with end cap
Step 1: Hub, upper pole shaft, and end cap.

Step 2: Insert the large petals

Insert the 4 large size petals into the two lower most rungs of holes on the hub. Place one tab of each petal in the lowest row, and the opposite tab of each petal into the row above so that each petal is fixed at a slight angle. Push hard to secure.

Each large petal uses two rows of holes, with one tab in the lowest row and the opposite tab in the row above it. When installed, the large petals form the lower outside layer of the rose at a slight angle.

Solar Flower - Rose large petals inserted into the two lower rows of the hub
Step 2: Large petals in the two lower rungs of holes.

Step 3: Insert the medium petals

Insert 3 medium size petals into the middle rung of holes. Push hard to secure.

Use the middle rung of holes on the hub. The medium petals sit as the next layer up from the large petals.

Solar Flower - Rose medium petals inserted into the middle row of the hub
Step 3: Medium petals in the middle rung of holes.

Step 4: Insert the small petals

Insert 3 small size petals into the top rung of holes. Push hard to secure.

Use the top row of holes on the hub for the small petals. These small petals form the upper layer of the rose.

Solar Flower - Rose small petals inserted into the top row of the hub
Step 4: Small petals in the top rung of holes.

Step 5: Check the finished rose

With all ten petals now inserted into three rungs of holes, you have created a beautiful Rose.

From above, the ten petals fill the three rungs of holes around the center of the hub. The finished rose has layered petals around the black center.

Solar Flower - Rose finished top view with ten petals installed
Step 5: Finished rose with all ten petals installed.

Step 6: Place the stake

Insert the finished pole into the ground shaft with pointed tip and drive it into soft ground. The Rose adorns your garden during the day and glows in different colors at night!

Use the ground shaft with the pointed tip in soft ground. After the rose is assembled on the finished pole, the pole fits into that ground shaft.

Before using the solar stake

Be sure to check your factory preinstalled batteries to see if they are still working. If not, replace batteries before using the solar stake.

Products this guide covers

Download the original manual

Solar Flower - Rose Assembly Instructions (PDF)

Latest Stories

This section doesn’t currently include any content. Add content to this section using the sidebar.