This guide covers assembly for the Premier Spinning Friend - Ladybug double ball spinner, size 17 in. x 31 in. It covers identifying the gores and support poles, attaching both gores, and connecting the support poles.
Applies to: Spinning Friend - Ladybug. See the 1 products this guide covers.
Assembly
Step 1: Identify the gores and support poles
Identify gores and support poles (Diagram A).
The Top Gores are the set with the ladybug face and antennae, and the Bottom Gores are the set with spots and legs. The Top Support Pole and Bottom Support Pole are separate poles with hubs on them.

Step 2: Attach the Upper Gore
Attach the Upper Gore. Stretch the set of gores so they are now surrounding the Top Support Pole. Starting with panel A of the Upper Gore, insert each gore strut into the strut holes on the top and bottom disc of the upper and lower hub (Diagram B).
The Upper Hub and Lower Hub are the two discs on the Top Support Pole. When the Upper Gore is attached, it forms a round spinner section around the Top Support Pole with the hubs at the top and bottom.

Step 3: Assemble the Bottom Gore
Repeat Step 2 to assemble the Bottom Gore.
Use the Bottom Gores with the Bottom Support Pole. The completed lower gore sits below the upper gore when the two support poles are connected.
Step 4: Connect the support poles
Next, connect the Upper and Lower Support Pole. Slide the Upper Support Pole through the Upper Hub on the Lower Support Pole. Then insert the Upper Support Pole into the ferrule of the Lower Support Pole (Diagram C).
The Upper Gore sits above the Lower Gore after the poles are joined. The ferrule is on the Lower Support Pole, and the Ground Stake is below the assembled spinner (Diagram C).

Panel removal note
Please note that if a mistake is made putting in the panels, they can be removed by unscrewing the hub. Use a small Phillips or flathead screwdriver.


Spinning Friend - Ladybug
Share:
Spinning Egg Spinner Assembly Instructions
Squeaky Kite Assembly Instructions