This guide covers assembly and launch instructions for the Premier 11 ft. Delta Kite. This guide covers the leading edge rods, center rod, spreader rod, tow point and wind-condition guidance from the manual.

Applies to: 11 ft. Delta Kite - Patriotic. See the 1 products this guide covers.

Product specs

Model Size Wind range Recommended line Frame Fabric
11 ft. Delta Kite - Patriotic 130 x 65 in. / 330 x 165 cm. 5 ~ 20 mph 150 lb. Test Line Recommended Carbon & Fiberglass Ripstop Polyester

Assembly

Step 1: Lay out the kite

Unroll kite and lay out flat facedown.

Lay the kite flat before you start joining the rods. The leading edge sleeves run along the two outside edges, and the center sleeve runs down the middle.

Step 2: Join the rods at the ferrules

Feel along Leading Edge Sleeves and Center Sleeve for ferrules. Join Leading Edge Rods and Center Rod at ferrules.

The leading edge rods sit inside the two slanted sleeves, and the center rod sits in the middle sleeve. The ferrules are the join points marked along those rods.

11 ft. Delta kite rods, ferrules, spreader pockets, tow point and launch direction
Assembly and launch details for steps 2-5.

Step 3: Slide the leading edge rods down

Slide Leading Edge Rods to bottoms of Leading Edge Sleeves.

Move each leading edge rod down its sleeve toward the lower end of the kite. The arrows on both leading edges point down to the bottom of the sleeve.

Step 4: Install the spreader rod

Join Spreader Rod at ferrule. Insert Spreader Rod into Pockets on Leading Edges.

The spreader rod runs across the kite from one leading edge to the other. The pockets are on the leading edges at both ends of the spreader rod.

Step 5: Attach the line

Attach Line to Tow Point, and your 11 ft. Delta is now ready to fly!

The tow point is on the keel at the front of the kite. The line leads from the flyer to that tow point during launch.

Flight instructions

Step 1: Tie on the flying line

Tie flying line to Tow Loop.

The tow point is on the keel; the flight instructions call this the Tow Loop. Tie the flying line there before launch.

Step 2: Position the kite for launch

Have a friend stand about 75 ft. downwind from you and hold the kite with its head pointed towards the sky.

Stand with your back to the wind, with your friend downwind from you. The kite connects to the line, with the keel at the front of the kite.

Step 3: Release the kite

As the wind catches the kite, signal your friend to release it while you bring in the line with long steady pulls.

Step 4: Let out line

Slowly let out more line as the kite flies upward.

Before you fly

The printed manual recommends 500 lb. test line; Premier's listing recommends 150 lb. test line for the 11 ft. Delta Kite - Patriotic.

Optimum wind conditions for 11 ft. Delta

Condition Manual description Wind [M.P.H.]
Calm smoke rises vertically 0
Light air Direction of wind shown by smoke, but not by wind vanes 1, 2, 3
Light breeze Wind felt on face, leaves rustle, ordinary vane moves 4, 5, 6, 7
Gentle breeze Leaves and small twigs in constant motion; wind extends light flag 8, 9, 10, 11, 12
Moderate breeze Raises dust and loose paper; small branches move 13, 14, 15, 16, 17, 18
Fresh breeze Small trees & leaves begin to sway; crested wavelets form on inland water 19, 20, 21, 22, 23, 24
Strong breeze Large branches in motion; utility wire whistle; windows rattle 25, 26, 27, 28, 29, 30
11 ft. Delta kite Beaufort wind chart with marked wind range
Optimum wind conditions for 11 ft. Delta.

Note: Wind conditions aloft may vary considerably from those found near ground level.

Products this guide covers

Download the original manual

11 ft. Delta Kite Assembly Instructions (PDF)

Latest Stories

This section doesn’t currently include any content. Add content to this section using the sidebar.