This guide covers assembly and basic flying for Premier 13 ft. Flo-Tail Delta kites. It applies to the Rainbow and Rainbow Burst designs.
Applies to: 13 ft. Flo-Tail Delta Kite - Rainbow and Rainbow Burst. See the 2 products this guide covers.
Product specs
| Model | Size (W x L) | Wind range | Recommended line | Frame | Fabric | Line included |
|---|---|---|---|---|---|---|
| 13 ft. Flo-Tail Delta - Rainbow and Rainbow Burst | 156 x 535 in. / 396 x 1359 cm | 6 ~ 20 mph | 250 lb. Test Line Recommended | Carbon & Fiberglass | Ripstop Polyester | Not Included |
Assembly
Step 1: Unfold the kite
Unfold the kite and lay it facedown on the ground. Set aside all struts. The Spine and Cross Strut parts will be grouped for you. The assembled Cross Strut will be shorter than the assembled Spine.
The Spine is the longer center strut group, and the Cross Strut is the shorter strut group that spans the kite side to side.
Step 2: Insert the spine
Assemble the Spine and slide it through the opening at the bottom of the Spine Sleeve. Securely fasten the Velcro tab. Occasionally the spine strut may jam up by the bridle knots around the spine sleeve during assembly. If this happens, simply loosen the bridle knot from the front of the kite so the spine has enough room to slide all the way through the spine sleeve.
The Spine Sleeve runs up the center of the kite, with its opening and Velcro tab at the bottom. When the Spine is in place, the bottom opening is closed with the Velcro tab.
Step 3: Insert the leading edge struts
Assemble one of the Leading Edge Struts and slide it through the opening at the top of the Leading Edge Strut Sleeve. The Leading Edge Strut Sleeve does not extend all the way to the Nose of the kite. Repeat with the remaining Leading Edge Strut.
Each Leading Edge Strut goes into a sleeve along one angled leading edge. The sleeve openings are below the Nose because the sleeves stop short of the Nose.
Step 4: Insert the cross strut
Assemble the Cross Strut and insert one end into one of the Cross Strut Pockets. Use the Loop on the other Pocket to pull the Pocket over the end of the Cross Strut.
The Cross Strut sits straight across the kite from one leading edge pocket to the other. The Loop is on the outside of the pocket at the end you pull over the Cross Strut.

Step 5: Tie the webbing strips
Loosely tie the Webbing strips at the Spine around the Cross Strut. The upper left strip should be tied to the bottom right strip and the upper right strip should be tied to the bottom left strip so that the loops create an 'x'.
Use the webbing strips at the Spine to make two loose loops around the Cross Strut. When the opposite strips are tied together, the loops cross in an X at the Spine.
To fly
Tie on the line and launch
Tie flying line to tow loop on the front of the kite. Have a friend stand about 75 ft. downwind from you and hold the kite with its Nose pointed towards the sky. As the wind catches the kite, signal your friend to release it while you bring in the line with long steady pulls. Slowly let out more line as the kite flies upward.
Have a friend stand about 75 ft. downwind from you. The Nose points toward the sky while your friend holds the kite for release.
Optimum wind conditions and line
Optimum wind conditions
Optimum wind conditions for 13' Flo-Tail Delta.
Recommended line
Recommended line: 250 - 500 lb test line.
Beaufort wind scale
| Beaufort scale | Wind [M.P.H.] | Manual description |
|---|---|---|
| Calm | 0 | Smoke rises vertically. |
| Light Air | 1, 2, 3 | Direction of wind shown by smoke, but not by wind vanes. |
| Light Breeze | 4, 5, 6, 7 | Wind felt on face, leaves rustle, ordinary vane moves. |
| Gentle Breeze | 8, 9, 10, 11, 12 | Leaves and small twigs in constant motion; wind extends light flag. |
| Moderate Breeze | 13, 14, 15, 16, 17, 18 | Raises dust and loose paper; small branches move. |
| Fresh Breeze | 19, 20, 21, 22, 23, 24 | Small trees & leaves begin to sway; crested wavelets form on inland water. |
| Strong Breeze | 25, 26, 27, 28, 29, 30 | Large branches in motion; utility wire whistle; windows rattle. |

Wind note
Note: Wind conditions aloft may vary considerably from those found near ground level.



13 ft. Flo-Tail Delta Kite - Rainbow
13 ft. Flo-Tail Delta Kite - Rainbow Burst
Share:
11 ft. Flapping Bat Kite Assembly Instructions
13 ft. Skeleton Kite Assembly Instructions