This guide covers assembly and flight setup for the Premier 14 ft. Delta Kite. It includes the frame rods, cross strut, keel tow point, launch steps, wind guide, and safety warning.

Applies to: 14 ft. Delta Kite - Red/White/Black. See the 1 products this guide covers.

Assembly

Step 1: Join the leading edge and center strut rods

Join the Leading Edge Rods and Center Strut Rods at their Ferrule Joints. For your convenience, all rods have been pre-placed in their correct fabric sleeves. To join the ferrules, simply feel along the sleeve for the ferrule joint and push into place. Make sure the Center Strut is fully inserted into the center sleeve. (Diagram A)

The two Leading Edge Sleeves run down the left and right edges of the kite, and the Center Strut Sleeve runs down the middle. Feel for each ferrule through the fabric sleeve before pushing the rod sections together.

Tip: IMPORTANT NOTE! Make sure the Leading Edge Rods are pushed all the way to the end of the Wingtips. There will be a short length of unfilled Leading Edge Sleeve by the nose -- do not worry about this, it is how the 12’ Delta frame should be.

14 ft. Delta kite leading edge sleeves and center strut sleeve
Diagram A: Leading edge sleeves and center strut sleeve.

Step 2: Insert the cross strut

Assemble Cross Strut and insert into Cross Strut Pockets. (Diagram B)

The Cross Strut runs across the kite from one Cross Strut Pocket to the other. Each end goes into a pocket at the side of the sail.

14 ft. Delta kite cross strut inserted across the sail into side pockets
Diagram B: Cross strut and cross strut pockets.

Step 3: Attach the flying line

Attach line to Keel Tow Point using a Larks Head Knot. (Diagram C)

Use the Tow Point on the Keel, at the position marked Normal Setting. The Flying Line attaches there with the Larks Head Knot shown.

14 ft. Delta kite keel tow point with Larks Head Knot and flying line
Diagram C: Keel tow point, normal setting, and Larks Head Knot.

Safety warning

CAUTION - CAUTION - CAUTIONUSE WITH EXTREME CARE! THIS KITE PRODUCES EXTRAORDINARILY STRONG PULLIt is the user’s sole responsibility to understand this warning and to exercise extreme caution while using this kite for traction or recreational flying purposes. The manufacturer accepts no responsibility for injuries to persons or damage to properties through the use of this product.

Flight instructions

Step 1: Have a friend hold the kite

Have a friend stand about 75 ft. downwind from you and hold the kite with its nose pointed towards the sky.

Your friend stands about 75 ft. downwind from you and holds the kite with its nose pointed towards the sky.

Step 2: Signal release

As the wind catches the kite, signal your friend to release it while you bring in the line with long steady pulls.

Step 3: Let out line

Slowly let out more line as the kite flies upward.

Wind guide and line

Condition Wind [M.P.H.] Description
Calm 0 smoke rises vertically
Light Air 1, 2, 3 Direction of wind shown by smoke, but not by wind vanes
Light Breeze 4, 5, 6, 7 Wind felt on face, leaves rustle, ordinary vane moves
Gentle Breeze 8, 9, 10, 11, 12 Leaves and small twigs in constant motion; wind extends light flag
Moderate Breeze 13, 14, 15, 16, 17, 18, 19 Raises dust and loose paper; small branches move
Fresh Breeze 20, 21, 22, 23, 24 Small trees & leaves begin to sway; crested wavelets form on inland water
Strong Breeze 25, 26, 27, 28, 29, 30 Large branches in motion; utility wire whistle; windows rattle
14 ft. Delta kite Beaufort wind chart with optimum wind conditions
Beaufort Scale: Wind guide and optimum wind conditions for 14’ Delta.

RECOMMENDED LINE: 150 LB TEST LINEOptimum wind conditions for 14’ Delta: 5-12 mph.Note: Wind conditions aloft may vary considerably from those found near ground level.

Products this guide covers

Download the original manual

14 ft. Delta Kite Assembly Instructions (PDF)

Latest Stories

This section doesn’t currently include any content. Add content to this section using the sidebar.