This guide covers assembly of Premier's 22 in. Motorcycle Spinner designs. Use it for the Flame and Patriotic motorcycle spinners.

Applies to: 22 in. Motorcycle - Flame and 22 in. Motorcycle - Patriotic. See the 2 products this guide covers.

Assembly

Step 1: Insert the upper support pole

Remove your 22" Motorcycle Spinner from the package. Open the Velcro seam along the bottom of the Motorcycle. Slide the narrow, plastic tipped end of the Upper Support Pole into the Star Lock Hub. Push down on the hub until the Support Pole locks into place and can not be removed. Close Velcro Seam. (Diagram A)

The Velcro seam is along the bottom edge of the motorcycle. The plastic tip is the narrow end at the top of the Upper Support Pole, and the Star Lock Hub sits inside the motorcycle above the seam.

Tip: To make insertion process easier, place bottom of Support Pole on a hard, flat surface and push down on Star Lock Hub.

Motorcycle Spinner star lock hub and upper support pole
Diagram A: Star Lock Hub and Upper Support Pole.

Step 2: Install the spinner wheels

Take one of the two Spinner Wheels and position it between the Axle Fittings on the Rear Wheel Assembly. Slide the Spinner Axle all the way through the Axle Fittings and Wheel. Pound the loose Velcro Covered Axle Cap onto the uncapped end of the Spinner Axle using a mallet or piece of wood. Repeat with Front Wheel Assembly. (Diagram B)

The Spinner Wheel sits between the two Axle Fittings on the Wheel Assembly. The Spinner Axle passes through the fitting, the center of the wheel, and the opposite fitting, with the loose Velcro Covered Axle Cap going onto the uncapped end.

Motorcycle Spinner wheel positioned between axle fittings
Diagram B: Spinner Wheel, Spinner Axle, and Axle Fitting.

Step 3: Attach the wheel assemblies

Slide the Rear Wheel Assembly and the Front Wheel Assembly onto the Strut Assembly. Make sure the headlight on the Front Wheel Assembly faces forward. Tighten the knobs on the T-Joints. (Diagram C)

After the wheel assemblies are on the struts, wrap the Velcro tabs around the struts as shown. The Velcro Covered Axle Caps sit at the wheel centers.

Motorcycle Spinner front and rear wheel assemblies with Velcro tabs
Diagram C: Wheel assemblies and Velcro tabs.

Step 4: Set the spinner on the ground stake

Drive Ground Stake into ground and insert the non-ferruled end of the Lower Support Pole into the Ground Stake. Insert Upper Pole of assembled Motorcycle Spinner into the ferrule. (Diagram D)

The ferrule is on the Lower Support Pole above the Ground Stake. The assembled motorcycle rests on the Upper Support Pole, which points down into the ferrule.

Motorcycle Spinner on upper and lower support poles with ground stake
Diagram D: Ground Stake, Lower Support Pole, ferrule, and Upper Support Pole.

Care and storage

PLEASE NOTE: It is recommended that you take your Motorcycle Spinner inside during storms and harsh weather to preserve its durability.

Products this guide covers

Download the original manual

22 in. Motorcycle Spinner Assembly Instructions (PDF)

Latest Stories

This section doesn’t currently include any content. Add content to this section using the sidebar.