This guide covers assembly for the 27 in. Pilot Pal Spinner designs. It shows how to install the wing struts, stabilizer strut, spinner propeller, support pole and ground stake.

Applies to: 27 in. Pilot Pal Spinner - Cat and Dog. See the 2 products this guide covers.

Specifications

Model Size (W x L)
Cat 27 in. x 17 in.
Dog 27 in. x 16 in.

Assembly

Step 1: Insert the wing struts

Insert the longer Wing Strut into the opening at the front wing tip of the wing. Slide it through the inside of the wing and through the Channel Hole in the fabric fuselage. Guide the Wing Strut through the Main Body Strut inside the fuselage and into the other wing to the end of the wing tip. This wing tip has no opening so the strut can not pass through. You may have to shift the Main Body Strut slightly to guide the Wing Strut through. Repeat with shorter Wing Strut in the opening at the back wing tip of the wing. (diagram A)

The longer Wing Strut is at the front wing-tip opening, and the shorter Wing Strut is at the back wing-tip opening. Both struts pass through the Channel Hole near the fuselage and across the Bottom View of Wings toward the opposite wing tip.

Pilot Pal Spinner wing struts through wing openings and channel hole
Diagram A: Bottom view of wings and wing struts.

Step 2: Insert the stabilizer strut

Insert the Stabilizer Strut into the opening on the Stabilizer. Slide it all the way through the Main Body Strut and Stabilizer to the opposite wing tip. (diagram B)

The Stabilizer Strut starts at the Strut Opening on the stabilizer and runs across the Bottom View of Stabilizer through the Channel Hole area. The Main Body Strut is centered where the stabilizer strut passes through.

Pilot Pal Spinner stabilizer strut through stabilizer opening and channel hole
Diagram B: Bottom view of stabilizer and stabilizer strut.

Step 3: Install the spinner propeller

Remove the wooden End Cap and Spacer from the Propeller Axle exiting from the front of the fuselage. Slide the Spinner Propeller onto the Axle. Replace the Spacer and wooden End Cap. (diagram C)

The Spinner Propeller goes on the Propeller Axle at the front of the fuselage. After the propeller is on the axle, the Spacer and End Cap return to the outside of the propeller as shown.

Pilot Pal Spinner propeller, axle, spacer, end cap and support pole ferrule
Diagram C: Spinner propeller, propeller axle and support pole ferrule.

Step 4: Attach the spinner to the support pole

Insert Upper Pole of assembled Pilot Pal Spinner into the ferrule at the top of the Support Pole. (diagram C)

The ferrule is at the top of the Support Pole. The assembled Pilot Pal Spinner sits above that ferrule, with the pole connection shown below the body.

Step 5: Set the ground stake and support pole

Drive Ground Stake into ground and insert the non-ferruled end of the Support Pole into the Ground Stake. (Diagram D)

The non-ferruled end of the Support Pole goes down into the Ground Stake. The Ground Stake is driven into the ground, with the Pilot Pal Spinner above the pole.

Pilot Pal Spinner on support pole with ground stake in the ground
Diagram D: Support pole and ground stake setup.

Weather note

Please note: It is recommended that you take your Pilot Pal Spinner inside during storms and harsh weather to preserve its durability.

Products this guide covers

Download the original manual

27 in. Pilot Pal Spinner Assembly Instructions (PDF)

Latest Stories

This section doesn’t currently include any content. Add content to this section using the sidebar.