This guide covers assembly for Premier 32 in. Motorcycle Spinners. The Flame and Patriotic designs use the same assembly steps.

Applies to: 32 in. Flame and Patriotic Motorcycle Spinners. See the 2 products this guide covers.

Assembly

Step 1: Connect the strut assembly sections

The Strut Assembly of your Motorcycle Spinner is shipped in three sections. Connect Center Rods of the Rear Strut Assembly and the Front Strut Assembly to the Center Rod of the Center Strut Assembly as shown. (diagram A)

The rear and front strut assemblies are labeled at the back and front wheel areas, and both have support rods. Bring the center rods toward the center strut assembly as the arrows show.

32 in. Motorcycle Spinner rear and front strut assemblies joining the center strut
Diagram A: Connect the rear and front strut assemblies to the center strut assembly.

Step 2: Slide the strut assembly into the body sleeve

Open all Velcro straps and slide completed Strut Assembly into bottom of Motorcycle Body Sleeve as shown. Reclose all Velcro straps. (diagram B)

The completed strut assembly goes up into the bottom of the Motorcycle Body Sleeve. Keep the rear wheel under the rear of the body sleeve and the front wheel under the front of the body sleeve.

32 in. Motorcycle Spinner body sleeve over the completed strut assembly with rear wheel detail
Diagram B: Slide the completed strut assembly into the Motorcycle Body Sleeve.

Step 3: Attach the rear wheel assembly

Attach Velcro connectors inside of the Motorcycle Body Sleeve. The Velcro will go over the side rods of the Rear Wheel Assembly. Axle rod needs to be slid through the tailpipe rods. Slide the wheels onto the spinner axle. Attach Velcro tabs on inside of both tailpipe sections on Motorcycle Body Sleeve to Velcroed Axle Caps on Rear Wheel Assembly. (diagram B inset)

At the rear wheel, close the Velcro pocket over the rod on both sides of the wheel. The inset also shows the Velcro tabs inside the tailpipe section attaching to the Velcroed Axle Caps on both sides of the wheel.

Step 4: Attach the front wheel assembly

Attach Velcro connectors on the inside of the Motorcycle Body Sleeve over the Front Struts of the Front Strut Assembly. Slide wheel onto axle. Attach Velcro tabs on the inside of the Motorcycle Body Sleeve to the Velcroed Axle Caps on the Front Wheel Assembly. (diagram C)

At the front wheel, the Velcro wraps around the strut inside the Body Sleeve. The Velcro tab inside the Body Sleeve connects to the axle caps.

32 in. Motorcycle Spinner front wheel with Velcro around strut and tabs to axle caps
Diagram C: Attach the front wheel assembly inside the Body Sleeve.

Step 5: Set the spinner on the support pole

Pound Ground Stake into ground and insert non-ferruled end of Support Pole into Ground Stake. Insert Upper Pole Section of completed Motorcycle Spinner into ferrule on top of Support Pole. (diagram D)

The Support Pole stands in the Ground Stake with the ferrule at the top. Lower the completed Motorcycle Spinner so its Upper Pole Section goes into that ferrule.

32 in. Motorcycle Spinner Upper Pole Section inserted into the ferrule on top of the Support Pole in the Ground Stake
Diagram D: Insert the Support Pole into the Ground Stake and insert the Upper Pole Section of the completed Motorcycle Spinner into the ferrule on top of the Support Pole.

Care note

Please note: Although your Flame Motorcycle Spinner or Patriotic Motorcycle Spinner is constructed with UV resistant SolarMax™ fabric, it is recommended that you take it inside during storms and harsh weather to preserve its durability.

Products this guide covers

Download the original manuals

Premier prints a manual for each design; the steps are the same apart from the differences noted above.

Latest Stories

This section doesn’t currently include any content. Add content to this section using the sidebar.