This guide covers assembly and basic flying for Premier 3D Shark Kites. It applies to both the 7 ft. and 11 ft. versions, with size-specific differences noted in the steps.
Applies to: 7 ft. and 11 ft. 3D Shark Kites. See the 2 products this guide covers.
Kite specifications
| Model | Size | Wind range | Line | Frame |
|---|---|---|---|---|
| 11 ft. 3D Shark Kite | 11 ft. / 335.28 cm | 5 ~ 18 mph | 90 lb. Test Line Recommended; line not included | Fiberglass |
| 7 ft. 3D Shark Kite | 7 ft. / 213.4 cm. | 5 ~ 18 mph | Includes 30# test 150 ft. on D handle. | Fiberglass |
Get ready
Step 1: Join the head stiffener struts
Join Head Stiffener Struts at Ferrule.
The ferrule is at the top of the head stiffener, joining the two head stiffener struts into one curved piece.
Tip: 11 ft. 3-D Shark only; the 7 ft. instructions begin with locating the leading edge openings.

Step 2: Insert the head stiffener
Locate the two openings in the Leading Edge. Bend the Head Stiffener and insert into the Leading Edge Pockets. Make sure that the Stiffener is slid fully into the Pockets.
The strut openings are on the leading edge near the head. The head stiffener strut sits behind the spine, and its ends go into the leading edge pockets.
Step 3: Install the spine strut
Join the Spine Strut at the Spine Ferrule. Slide the Spine through the Spine Sleeve and insert the ends of the Spine into the Spine Pockets. The Spine goes in front of the Head Stiffener.
The spine sleeve runs along the center of the back of the kite. The spine pockets are at the head and lower body, with the spine ferrule near the middle.
Tip: 11 ft. 3-D Shark only; the 7 ft. instructions do not include this spine-strut step.
Step 4: Insert the cross strut
Insert the Cross Strut into Cross Strut Pockets. The Cross Strut goes in front of the Spine.
The cross strut runs across the body into the cross strut pockets on both sides. It sits in front of the spine.
Step 5: Insert the tail stiffener
Insert the Tail Stiffener into the Leading Edge Pockets in the Tail Fins.
The tail stiffener spans the tail area. The leading edge pockets are on the tail fins.
Step 6: Attach the flying line
Attach the flying line to the tow point on the front of the Bridle.
Use the front of the kite for this connection. The bridle lines meet at the tow point.
To fly
Launch the kite
Have a friend stand about 75 feet downwind from you and hold the kite with its nose pointed towards the sky. As the wind catches the kite, signal your friend to release it while you steadily pull in line until the kite is aloft. As the kite flies upward, slowly release more line.
Stand upwind of your friend. Keep the nose pointed toward the sky as your friend holds the kite downwind from you.
Products this guide covers
Download the original manuals
Premier prints a manual for each design; the steps are the same apart from the differences noted above.


7 ft. 3D Shark Kite
11 ft. 3D Shark Kite
Share:
38 in. Travel Diamond Kite Assembly Instructions
4 Legged WhirliGig Spinner Assembly Instructions