This guide covers assembly and flying for the Premier 5 ft. Shark Kite in black. It shows where to place the cross strut, head stiffener strut, and flying line before launch.
Applies to: 5 ft. Shark Kite - Black. See the 1 products this guide covers.
Specifications
| Model | Size | Wind range | Line | Frame |
|---|---|---|---|---|
| 5 ft. Shark Kite - Black | 41 x 60 in. / 104 x 152 cm. | 5 ~ 18 mph | 300 ft. 30 lb. Test Line & Winder included | Fiberglass |
Get ready
Step 1: Insert the cross strut
Insert the cross strut into the pockets at the leading edge.
Work from the back of the kite for the frame steps. The cross strut runs across the upper body of the kite, with its ends going to the leading-edge pockets.

Step 2: Install the head stiffener strut
Bend head stiffener strut and slip into strut opening. Push strut all the way down into sleeves.
The head stiffener strut sits in the head area above the spine strut. The back view shows the head stiffener strut curved across the head once it is in place.
Step 3: Attach the flying line
Attach your line to the tow point.
The tow point is marked on the front of the kite, near the upper body. Premier’s Shark Kites use 30 lb. Test Line.
To fly
Step 1: Position the kite
Have a friend stand about 75 feet downwind from you and hold the kite with its nose pointed towards the sky.
Stand with your back to the wind so the kite and your friend are downwind from you. Keep the nose of the shark pointed up toward the sky before the release.
Step 2: Release and pull in line
As the wind catches the kite, signal your friend to release it while you steadily pull in line until the kite is aloft.
Step 3: Let out more line
As the kite flies upward, slowly release more line.
Safety
WARNING: CHOKING HAZARD - Small parts. Not for children under 3 years. Do not use near overhead power lines or during thunderstorms.


5 ft. Shark Kite - Black
Share:
40 in. New Holland Tractor Spinner Assembly Instructions
52 in. Travel Diamond Kite Assembly Instructions