This guide covers assembly and flying for the Premier Ace Sport Kite. It includes cross strut setup, flying line attachment, pre-flight setup, launch, control, landing and safety information.

Applies to: Ace Sport Kite - Green. See the 1 products this guide covers.

Ace Sport Kite specs

Model Size Wind range Line Frame
Ace Sport Kite - Green 35.5 x 38 in. / 90 x 97 cm. 8 ~ 18 mph Included Fiberglass

Assembly

Step 1: Insert one end of the cross strut

Insert one end of the Cross Strut into the Cross Strut Pocket. Make sure that the Bridle Lines are not twisted around the Spine. (diagram A)

The Cross Strut runs across the upper part of the kite and crosses the Spine at the O-Ring. Keep the Bridle Lines free of the Spine while you place the first end into the pocket.

Ace Sport Kite with one end of the Cross Strut in a pocket
Diagram A: Insert one end of the Cross Strut into the Cross Strut Pocket.

Step 2: Bow the cross strut into the remaining pocket

Bow the Cross Strut to insert the other end into the remaining pocket. Shift the O-Ring around the struts until the struts lay flat against the kite. The white marks on the struts should line up under the O-Ring. Adjust the Bridle Lines along the struts until they are positioned directly behind the Bridle Line reinforcements. (diagram B)

When this step is set correctly, the Cross Strut forms a smooth bow and both ends are in the Cross Strut Pockets. The white marks meet under the O-Ring, and the Bridle Lines sit in position on the struts behind the Bridle Line reinforcements.

Ace Sport Kite with bowed Cross Strut and bridle lines positioned
Diagram B: Bow the Cross Strut and line up the white marks under the O-Ring.

Step 3: Attach the flying line

Turn the kite over and attach the Flying Line using a Larks Head Knot. (diagram C)

Use the Larks Head Knot at the bridle attachment point marked “Attach line.” The inset shows the Flying Line attached to the Bridle.

Ace Sport Kite flying line attached to the bridle with a Larks Head Knot
Diagram C: Attach the Flying Line to the Bridle.

Safety first

Be sure to avoid flying near cars, people, power lines and airports. Stunt kites can move at high speeds and are capable of inflicting damage on people and property. Both the kite and flying lines represent potential hazards. The kite and line can hit or cut with high force while moving at high speeds. Use your stunt kite with extreme care. Flying safely is your sole responsibility.

Flying

Pre-flight

Place your Ace on the ground with the kite's back against the ground. After hooking your lines up to the bridle points, unroll the lines all the way to the end. Hold the flying handles together and make sure your lines are even. Your lines come pre-tied at the factory to even lengths. If they have stretched or are different lengths, simply shorten the longer line to match the shorter line.Stand with the wind at your back and flying lines fully extended. Have a friend hold the kite with the nose pointing skyward. Keep your hands forward and parallel. (diagram D)

Your helper holds the kite at the far end of the fully extended lines. Stand with the wind at your back, with your hands forward and parallel before launch.

Ace Sport Kite held nose skyward with flyer standing with wind at back
Diagram D: Pre-flight position with wind at your back.

Launch

Tell your friend to release the kite. Pull both lines back with equal tension to launch the kite. Immediately return hands forward. (diagram E)

The kite rises from your helper as you pull both lines back. Return both hands forward right away after the kite launches.

Ace Sport Kite launching as the flyer pulls both lines back
Diagram E: Pull both lines back with equal tension to launch.

Control

On your first launch, keep your hands next to each other and let your kite ascend as high as possible. If your kite wanders to one side, make corrections by pulling on the opposite control handle. A stunt kite turns towards the same direction it is pulled: Pull right - the kite turns right, pull left the kite turns left. As a beginner, concentrate on steering towards the sky and maintaining plenty of altitude before doing complex stunts. (diagram F)The most common problem a beginner has is over controlling their kite. Only a few inches of pull is needed for maneuvering. If you continue to pull to one side, your kite will make a loop. The further you pull back the line, the tighter the loop will be. At any point in the loop or turn, you can even out your hands and the kite will continue in the direction the nose is pointing.After doing loops, your control lines will be twisted. This may seem troublesome, but don't worry, you still have control of your kite. To untwist, simply fly loops in the opposite direction.Pull Left: Kite Turns Left. Handles Even: Kite flies straight in the same direction it is pointing. Pull Right: Kite Turns Right.

Keep the handles even when you want the kite to fly straight in the direction its nose is pointing. Pull left to turn left, and pull right to turn right.

Ace Sport Kite turning left, flying straight, and turning right by handle position
Diagram F: Pull left, handles even, and pull right controls.

Landing

Notice that as the kite flies to the edge of the wind window, it slows down and eventually stalls. Maneuver the kite to the outermost edge about a foot off the ground and run toward the kite while throwing your arms forward. Your lines will go slack and the kite will gently land.

Wind conditions

Optimum wind conditions for Ace Sport Kite.

Best wind for Ace Sport Kite: 8-18 mph.

Note: Wind conditions aloft may vary considerably from those found near ground level.

Ace Sport Kite wind chart showing optimum range from 8 to 18 mph
Optimum wind conditions for Ace Sport Kite.

Products this guide covers

Download the original manual

Ace Sport Kite Assembly Instructions (PDF)

Latest Stories

This section doesn’t currently include any content. Add content to this section using the sidebar.