This guide covers assembly for Premier Butterfly Spinner designs. It shows how to unfold the wings, match the numbered struts to the rotating hub, assemble the support pole, and set the ground stake.

Applies to: Butterfly Spinner - Blue, Monarch, and Rainbow. See the 3 products this guide covers.

Assembly

Step 1: Unfold the wings

Remove butterfly wings from packaging and unfold. Make sure the struts are facing the floor. (diagram A)

Keep the struts under the fabric as shown near the center of the wings. The numbered strut ends should be visible near the center of each wing after the wings are unfolded.

Butterfly Spinner wings unfolded with struts under the fabric
Diagram A: Keep struts under fabric.

Step 2: Match the wing numbers to the hub

Line up the numbers on the wing struts with the numbers on the hub. Keep the top of the hub up and the wing struts facing the floor. (diagram B)

The hub is numbered around its center, and the wing struts have matching numbered ends. Position the wings so each numbered strut end is beside the same number on the hub.

Butterfly Spinner wing strut numbers matched to the hub numbers
Diagram B: Position wings so numbers match hub.

Step 3: Insert the struts into the hub

Insert the numbered struts into their matching holes in the rotating hub. (diagram C)

The holes are around the side of the rotating hub. Follow the numbered positions so each strut goes into the matching hole.

Butterfly Spinner numbered struts inserted into matching hub holes
Diagram C: Insert struts into matching numbered holes.

Step 4: Assemble the support pole

Assemble the four parts of the Support pole and tighten the Hex Screw on the upper ferrule and the Hex Screw on the middle Ferrule using the included Allen Wrench. (diagram D)

Slide the support pole sections together in the order shown, with the butterfly at the top. The screws sit at the upper ferrule and the middle ferrule, and the Allen wrench sits at the screw location.

Butterfly Spinner support pole assembled and inserted into the ground stake
Diagram D: Connect support poles and slide into ground stake.

Step 5: Set the ground stake

Pound Ground Stake into ground and insert non-ferruled end of Support Pole into Ground Stake. (diagram D)

The ground stake sits in the ground below the support pole. Insert the bottom, non-ferruled end of the support pole into the ground stake.

Care and wind range

Please note: Although your Butterfly Spinner is constructed with UV resistant SunTex™ fabric, it is recommended that you take it inside during storms and harsh weather to preserve its durability. Wind Range 0-18 mph.

Products this guide covers

Download the original manual

Butterfly Spinner Assembly Instructions (PDF)

Latest Stories

This section doesn’t currently include any content. Add content to this section using the sidebar.