This guide covers assembly of the Premier Flying Flamingo Spinner. It applies to the Traditional Bird spinner platform in the 48 in. x 40 in. Flying Flamingo design.

Applies to: Flying Flamingo Spinner. See the 1 products this guide covers.

Assembly

Step 1: Connect the strut assembly

The Strut Assembly of your Flying Flamingo Spinner is shipped in three sections. Connect rod of Head Section to Wing Hub Assembly by joining ends of Ferrule Connectors at front (end opposite Metal "T" Joint). Connect rod of Tail Section to Wing Hub Assembly by joining ends of Ferrule Connectors at back (end with Metal "T" Section). (diagram A)

The Head Section connects to the front of the Center Wing Hub, and the Tail Section connects to the back. The Vertical Support Rod and Metal "T" Section sit near the tail end, with the head and tail rods sliding into the Ferrule Connectors.

Flying Flamingo Spinner strut assembly with head section, tail section, ferrule connectors, and wing hub
Diagram A: Strut assembly sections and ferrule connectors

Step 2: Install the vertical support rod

Slide Vertical Support Rod into opening of vertical pocket in Tail Section, just above Metal "T" Joint. Fit uncapped end into vertical section of Metal "T" Joint and capped end into top of pocket. (diagram B)

The vertical pocket is in the Tail Section above the Metal "T" Joint. The Metal "T" Joint slides into the horizontal pocket on the Tail Section, and the Vertical Support Rod sits in the vertical pocket with its capped end at the top.

Flying Flamingo Spinner tail section with vertical support rod, Metal T Joint, and pockets
Diagram B: Vertical Support Rod and Metal "T" Joint in the Tail Section

Step 3: Attach the wing fins

Attach Wing Fins to Wing Hub. Please note that Wing Fins are inserted at an offset pattern. Make sure Wing Fins are fully inserted into hub holes. You will hear a “click” sound when the pins are all the way in. (diagram C)

The Wing Fin Pins line up with the Hub Holes on the Wing Hub. Insert the pins into the hub holes in the offset pattern shown so the wing fins sit around the hub.

Tip: If you make a mistake in the placement of the Wing Fins, such as backward or in the wrong color sequence, you can remove them by carefully inserting a small flat end screwdriver between the base of the Wing Fin Pin and the hub and pushing it up and out.

Flying Flamingo Spinner wing fins with wing hub, hub holes, and wing fin pins
Diagram C: Wing Fins, Wing Hub, and Wing Fin Pins

Step 4: Set the spinner on the ground shaft

Drive Ground Stake into ground. Slide Ground Shaft into Ground Stake. Slide Main Hub Assembly with Garden Spinner over Ground Shaft Ferrule. If you desire extra height, add extra ground shaft included in this package. (diagram D)

The support pole stands in the Ground Stake, and the ferrule is at the top of the support pole. Lower the assembled spinner onto the Ground Shaft Ferrule as shown.

Flying Flamingo Spinner on support pole with ferrule and ground stake
Diagram D: Ground Stake, support pole, and ferrule

Care and storage

Although your Garden Spinner is constructed with UV resistant SolarMax fabric, to preserve its durability, we recommend taking spinner inside during harsh weather or when not in use.

Products this guide covers

Download the original manual

Flying Flamingo Spinner Assembly Instructions (PDF)

Latest Stories

This section doesn’t currently include any content. Add content to this section using the sidebar.