This guide covers assembly for the Premier 37 in. Horse & Buggy Spinner. Connect the strut assemblies, install the spinner axles and wheels, and mount the spinner on its support pole.
Applies to: 37 in. Horse & Buggy Spinner. See the 1 products this guide covers.
Assembly
Step 1: Insert the strut assembly
The Strut Assembly of your Horse and Buggy spinner is shipped in four sections. Connect Center Rod of the Rear Strut Assembly to the Center Rod of the Center Strut Assembly. Open Velcro straps and insert Strut Assembly into bottom of Horse and Buggy Body Sleeve as shown. Make sure all internal body struts are connected to the strut assemblies. (diagram A)
The Rear Strut Assembly and Center Strut Assembly join below the Horse and Buggy Body Sleeve. The Internal Body Struts sit inside the top of the buggy body, and the joined strut assembly goes up into the body sleeve.

Step 2: Attach the center and front strut assemblies
Attach the Center Strut Assembly to the Front Strut Assembly that is already inside the Body Sleeve. You will have to bend the Body Sleeve to fit the Strut Assembly together. (diagram B)
The connection is under the front part of the Horse and Buggy Body Sleeve, where the front and center strut assemblies meet.

Step 3: Install the rear spinner axle
Take one of the Spinner Axles and slide it onto the Rear Strut Assembly at back of Horse and Buggy Body. Tighten the knob on the "T" Joint to hold the Axles to the Struts. (diagram D)
The "T" Joint sits below the Horse and Buggy Body, and the Spinner Axle extends out to both sides. First slide the Spinner Axle onto the Strut Assembly, then tighten the knob on the "T" Joint.

Step 4: Add the rear spinner wheels
Take one of the four Spinner Wheels and slide it onto one of the two Spinner Axles. Slide second Spinner Wheel onto Spinner Axle. (Note: Spinner Wheels on same side of Horse and Buggy should spin in same direction and Spinner Wheels on same axle should spin in opposite directions. Before putting second Axle Cap into place, make sure wheels spin as shown in diagrams E and F.) Pound second Axle Cap onto uncapped end of Spinner Axle using a mallet or piece of wood. (diagram E)
One Spinner Wheel goes on each side of the Spinner Axle. After the wheels are on the axle, put the Axle Cap onto the uncapped end.

Step 5: Assemble the front spinner
Repeat Step 4 using second Spinner Axle and the two remaining Spinner Wheels to assemble front Spinner.
Step 6: Mount the spinner on the pole
Pound Ground Stake into ground and insert non-ferruled end of Support Pole into Ground Stake. Insert Upper Pole Section of completed Horse and Buggy Spinner into ferrule on top of Support Pole. (diagram F)
The Support Pole stands in the Ground Stake, with the ferrule at the top. Insert the Upper Pole Section of the completed Horse and Buggy Spinner into the ferrule on top of the Support Pole.

Care note
Please note: Although your Horse and Buggy Spinner is constructed with UV resistant SunTex™ fabric, it is recommended that you take it inside during storms and harsh weather to preserve its durability.


37 in. Horse & Buggy Spinner
Share:
High Wheel Bike Spinner Assembly Instructions
Hot Air Balloon Assembly Instructions