This guide covers assembly for the Premier Mallard Umbrella Spinner. It follows the manufacturer’s steps for the umbrella spinner, figure, support pole and ground stake.

Applies to: Mallard Umbrella Spinner. See the 1 products this guide covers.

Product specs

Product Size (W x L)
Mallard Umbrella Spinner 24 in. x 33.5 in.

Assembly

Step 1: Unfold the gore panels

Remove gore panels from package and unfold. Make sure that the lower edge binding tape is not twisted or bunched. (Diagram A)

The gore struts extend upward from the gore panels. The lower edge binding tape runs around the bottom edge of the ring.

Mallard Umbrella Spinner gore panels with gore struts and lower edge binding tape
Diagram A: Gore panels, gore struts and lower edge binding tape.

Step 2: Slide in the Main Rotating Hub Assembly

Slide the Main Rotating Hub Assembly through the center of the ring of gore panels with the support struts all facing up and curved in the same direction. (Diagram B)

The Main Rotating Hub Assembly sits in the center of the ring of gore panels. Keep the support struts above the panels, all facing up and curved in the same direction.

Mallard Umbrella Spinner Main Rotating Hub Assembly in the center of the gore panels
Diagram B: Main Rotating Hub Assembly through the gore panels.

Step 3: Insert the gore struts

Insert the gore struts into the strut holes on the top disc of the Main Rotating Hub Assembly. (Diagram C)

Use the strut holes around the top disc of the Main Rotating Hub Assembly. The gore struts angle inward toward the hub as they go into the holes.

Mallard Umbrella Spinner gore struts inserted into strut holes on the top disc
Diagram C: Gore struts into the strut holes.

Step 4: Insert the Vertical Strut

Insert the Vertical Strut into the Main Strut Assembly inside the figure. (Diagram D)

The Main Strut Assembly is inside the figure. Lower the Vertical Strut from the umbrella spinner into that assembly so the umbrella sits above the figure.

Mallard Umbrella Spinner Vertical Strut lowering into the Main Strut Assembly
Diagram D: Vertical Strut into the Main Strut Assembly.

Step 5: Insert the Support Pole

Insert the Support Pole into the Main Strut Assembly. (Diagram E)

The Support Pole comes up from below the figure toward the Main Strut Assembly. Align it straight beneath the Main Strut Assembly as shown.

Mallard Umbrella Spinner Support Pole raised into the Main Strut Assembly
Diagram E: Support Pole into the Main Strut Assembly.

Step 6: Install the ground stake

Drive Ground Stake into ground. Slide Support Pole into Ground Stake. If you desire extra height, add the extra ground shaft included in this package. (Diagram F)

The Ground Stake is in the ground, with the Support Pole sliding down into it. The completed spinner stands above the Ground Stake with the Support Pole vertical.

Mallard Umbrella Spinner Support Pole sliding into the Ground Stake
Diagram F: Support Pole into the Ground Stake.

Care note

Please note: Although your Garden Spinner is constructed with UV resistant SunTex™ fabric, it is recommended that you take it inside during storms and harsh weather to preserve its durability.

Products this guide covers

Download the original manual

Mallard Umbrella Spinner Assembly Instructions (PDF)

Latest Stories

This section doesn’t currently include any content. Add content to this section using the sidebar.