This guide covers assembly of the Premier Petite Spinner - Dirigible. It shows how to install the wings on the horizontal axle and connect the support pole for display.

Applies to: Petite Spinner - Dirigible. See the 1 products this guide covers.

Assembly

Step 1: Add the first nylon washer

Slide one Nylon Washer onto the Horizontal Axle.

The horizontal axle runs through the hub on the side of the dirigible. This washer goes on before the wings.

Step 2: Install the wings and end cap

Slide on Wings and second Nylon Washer. Attach End Cap. Please note the End Cap needs to be pushed on the rear of the axle with some force. A light tap with a small hammer or hard blunt object works well to permanently secure the End Cap.

The wings sit between the two nylon washers. The end cap goes on the outside at the rear of the axle.

Step 3: Lock the upper support pole into the hub

Slide the narrow tip of Upper Support Pole into Hub. Push the Support Pole firmly down until it locks into place and cannot be removed. This is best done with the base of the Upper Support Pole on a hard surface and pushing the pole into place.

The upper support pole stands vertically below the hub. The narrow tip goes into the hub, with the pole pushed down into place.

Step 4: Connect the support poles and place in the ground

Connect Upper Support Pole with Lower Support Pole and insert into the ground.

Join the upper support pole to the lower support pole at the ferrule. The lower support pole is the section that inserts into the ground.

Mounting note

Compatible with Premier’s 6 mm Deck Mount (sold separately).

Products this guide covers

Download the original manual

Petite Spinner - Dirigible Assembly Instructions (PDF)

Latest Stories

This section doesn’t currently include any content. Add content to this section using the sidebar.