This guide covers assembly for the Premier Petite Spinner - Whale, a 16.5 in. x 12 in. petite spinner.

Applies to: Petite Spinner - Whale. See the 1 products this guide covers.

Assembly

Step 1: Add the first washer

Slide one Nylon Washer onto the Horizontal Axle.

The Horizontal Axle runs through the whale body from the Hub toward the spinner assembly. Put the Nylon Washer onto that axle before adding the wings.

Step 2: Add the wings and end cap

Slide on Wings and second Nylon Washer. Attach End Cap.

The wings fit on the Spinner Axle at the side of the whale. The second Nylon Washer goes outside the wings, followed by the End Cap.

Step 3: Lock the upper support pole into the hub

Slide the narrow tip of Upper Support Pole into Hub. Push the Support Pole firmly down until it locks into place and cannot be removed. This is best done with the base of the Upper Support Pole on a hard surface and pushing the pole into place.

The narrow tip of the Upper Support Pole goes into the Hub under the whale body. The pole sits vertically below the spinner when it is in place.

Step 4: Connect the lower support pole

Connect Upper Support Pole with Lower Support Pole and insert into the ground.

Join the Upper Support Pole to the Lower Support Pole at the Ferrule. The Lower Support Pole points down and is the section inserted into the ground.

Mounting note

Compatible with Premier’s 6 mm Deck Mount (sold separately).

Products this guide covers

Download the original manual

Petite Spinner Whale Assembly Instructions (PDF)

Latest Stories

This section doesn’t currently include any content. Add content to this section using the sidebar.