Use this guide to assemble the Speedboat Garden Spinner. It covers the strut assembly, body sleeve, wing fins, ground stake and support pole.

Applies to: Speedboat Garden Spinner. See the 1 products this guide covers.

Assembly

Step 1: Connect the strut assembly

The Strut Assembly of your Speed Boat Spinner is shipped in two sections. Connect Center Rod of Rear Strut Assembly to Center Rod of Front Strut Assembly by joining ends of Non-Rotating Ferrule Connector as shown. (diagram A)

The Front Strut Assembly includes the Vertical Support Rod. Bring the two Non-Rotating Ferrule Connector ends together so the Center Rods of the front and rear strut assemblies join in line.

Premier Speedboat strut assembly with vertical support rod and ferrule connector ends
Diagram A: Connect the front and rear strut assemblies.

Step 2: Insert the strut assembly into the body sleeve

Open velcro straps and insert completed Strut Assembly into bottom of Speed Boat Body Sleeve as shown. Reclose velcro straps. (diagram B)

The Speed Boat Body Sleeve is along the bottom of the boat body, with the velcro straps underneath it. The completed Strut Assembly goes up into the bottom of the sleeve, with the Vertical Support Rod below the boat body.

Premier Speedboat body sleeve and velcro straps above the completed strut assembly
Diagram B: Insert the completed strut assembly into the body sleeve.

Step 3: Attach the wing fins

Attach Wing Fins to Wing Hub. Please note that Wing Fins are inserted at an offset pattern. Make sure Wing Fins are fully inserted into hub holes. You will hear a “click” sound when the pins are all the way in. (diagram C)

Each Wing Fin Pin goes into a Hub Hole on the Wing Hub. The wing fins are staggered in the offset pattern shown, not lined up straight across from each other.

Premier Speedboat wing fins with wing fin pins aligned to the hub holes
Diagram C: Attach the wing fins to the wing hub.

Step 4: Install the spinner on the support pole

Pound Ground Stake into ground and insert non-ferruled end of Support Pole into Ground Stake. Insert Upper Pole Section of completed Speed Boat Spinner into ferrule on top of Support Pole. (diagram D)

The Ground Stake sits in the ground, with the Support Pole standing upright in it. The completed Speed Boat Spinner lowers onto the ferrule at the top of the Support Pole.

Premier Speedboat spinner lowering onto the support pole in the ground stake
Diagram D: Install the spinner on the support pole.

Care note

Please note: Although your Speed Boat Spinner is constructed with UV resistant SunTex™ fabric, it is recommended that you take it inside during storms and harsh weather.

Products this guide covers

Download the original manual

Speedboat Garden Spinner Assembly Instructions (PDF)

Latest Stories

This section doesn’t currently include any content. Add content to this section using the sidebar.