This guide covers assembly and flying setup for the Premier Strata Delta kite. It applies to the Tortuga Rainbow design.

Applies to: Stratadelta Kite - Tortuga Rainbow. See the 1 products this guide covers.

Strata Delta specifications

Model Size (W x L) Wind range Line Frame Fabric
Tortuga Rainbow 108 x 45 in. / 274 x 114 cm. 7 ~ 20 mph 150 lb. Test Line Recommended; not included Carbon & Fiberglass Ripstop Polyester

Assembly

Step 1: Unfold the kite

Unfold kite making sure that the keels are on the bottom.

Step 2: Connect the cross struts

Connect the two horizontal cross struts. (Diagram A)

The horizontal cross struts are the two long rod sections shown for this step. Their inner ends line up to form one cross strut (Diagram A).

Strata Delta horizontal cross struts shown as two rod sections
Horizontal Cross Struts.
Strata Delta cross strut through center sleeve and into spar pockets
Diagrams A and B: horizontal cross struts, center sleeve and spar pockets.

Step 3: Slide the leading edge spars

Slide leading edge spars out to wing tips.

The leading edge rods run inside the kite along the two slanted leading edges. Slide each spar outward toward its wing tip before installing the horizontal cross strut.

Step 4: Insert the horizontal cross struts

Insert the horizontal cross struts through the center sleeve and into the spar pockets on either side of the kite. (Diagram B)Kite is now ready to fly.

The center sleeve sits near the middle of the kite. The end of the horizontal cross strut sits in the spar pocket on the side of the kite (Diagram B).

Flight instructions

Step 1: Attach the flying line

Attach flying line to Tow Loop.

Step 2: Position your helper

Have a friend stand about 75 ft. downwind from you and hold the kite with its Leading Edge pointed towards the sky.

Your friend should stand about 75 ft. downwind from you and hold the kite with its Leading Edge pointed towards the sky.

Step 3: Release the kite

As the wind catches the kite, signal your friend to release it while you bring in the line with long steady pulls.

Step 4: Let out line

Slowly let out more line as the kite flies upward.

Recommended line and wind note

Recommended line: 150 LB TEST LINE.Note: Wind conditions aloft may vary considerably from those found near ground level.

Optimum wind conditions for Strata Delta

Beaufort scale Description M.P.H.
Calm Smoke rises vertically 0
Light Air Direction of wind shown by smoke, but not by wind vanes 1 2 3
Light Breeze Wind felt on face, leaves rustle, ordinary vane moves 4 5 6 7
Gentle Breeze Leaves and small twigs in constant motion; wind extends light flag 8 9 10 11 12
Moderate Breeze Raises dust and loose paper; small branches move 13 14 15 16 17 18
Fresh Breeze Small trees & leaves begin to sway; crested wavelets form on inland water 19 20 21 22 23 24
Strong Breeze Large branches in motion; utility wire whistle; windows rattle 25 26 27 28 29 30
Strata Delta Beaufort wind chart with wind speeds from 0 to 30 mph
Optimum wind conditions for Strata Delta.

Products this guide covers

Download the original manual

Strata Delta Assembly Instructions (PDF)

Latest Stories

This section doesn’t currently include any content. Add content to this section using the sidebar.