This guide covers assembly for the 19 in. Teardrop Camper Spinner. Set up the fabric body, support pole, axles, spinner wheels and ground stake.

Applies to: 19 in. Teardrop Camper Spinner. See the 1 products this guide covers.

Assembly

Step 1: Install the support pole

Remove your Camper Spinner from the package and unfold the fabric Body. Open the Velcro seam along the bottom of the Spinner and slide the narrow, plastic tipped end of the Support Pole into Star Lock Hub. Push down on the hub until the Support Pole locks into place and can not be removed. Close Velcro Seam. Completed internal Strut Assembly should match Diagram A.

The Star Lock Hub is inside the body near the center, above the bottom Velcro seam. The Support Pole runs down from the hub through the open seam at the bottom.

Tip: To make insertion process easier, place bottom of Support Pole on a hard, flat surface and push down on Star Lock Hub.

Teardrop Camper Spinner internal strut assembly with Star Lock Hub and Support Pole
A: Internal strut assembly

Step 2: Attach the spinner axles

Slide the Spinner Axles onto the Wheel Strut Assemblies. Tighten knobs on the "T" Joints to hold the Axles to the Struts. (Diagram B)

The "T" Joint sits at the bottom of the Wheel Strut Assembly, below the wheel opening. The Spinner Axle passes horizontally through the "T" Joint before the knob is tightened.

Teardrop Camper Spinner axle sliding onto the strut assembly at the T Joint
B: Spinner Axle and T Joint

Step 3: Install the spinner wheels and axle caps

Take one of the two Spinner Wheels and slide it onto one of the Spinner Axles. Slide the second Spinner Wheel onto the Spinner Axle. (Note: Spinner Wheels on same axle should spin in opposite directions. Before putting second Axle Cap into place, make sure wheels spin as shown in diagrams C and D.) Pound Axle Caps onto uncapped ends of Spinner Axle using a mallet or piece of wood. (Diagram C)

The two Spinner Wheels are on the same Spinner Axle, one on each side of the "T" Joint (Diagram C). The Axle Caps go on the outside uncapped ends of the Spinner Axle, and the curved arrows show the wheels spinning in opposite directions.

Teardrop Camper Spinner wheels on one axle with axle caps and opposite spin arrows
C: Spinner Wheels and Axle Caps

Step 5: Place the spinner on the ground stake

Drive Ground Stake into ground. Slide assembled Car Spinner into Ground Stake. (Diagram D)

The Ground Stake stands upright in the ground. The Support Pole slides down into the Ground Stake with the Camper Spinner body above it.

Teardrop Camper Spinner support pole sliding into the ground stake
D: Ground Stake installation

Care note

Please note: It is recommended that you take your Car Spinner inside during storms and harsh weather to preserve its durability.

Products this guide covers

Download the original manual

Teardrop Camper Spinner Assembly Instructions (PDF)

Latest Stories

This section doesn’t currently include any content. Add content to this section using the sidebar.