This guide covers assembly of Premier Triple Spinner garden spinners. It applies to the 33 in. x 27 in. designs listed here, with notes for the wheel and end-cap differences between design groups.
Applies to: Premier 33 in. x 27 in. Triple Spinner designs. See the 26 products this guide covers.
Assembly
Step 1: Assemble the sail
Slide the upper support rod attached to the hub into the vertical sleeve on the sail. Insert the sail strut into the sleeve opening and slide it all the way through the horizontal sleeve and into the Aluminum Ferrule. The sail assembly is now complete. (Diagram A)
The upper support rod runs down the vertical sleeve at the side of the sail. The sail strut goes through the sleeve opening across the top edge of the sail and into the Aluminum Ferrule.

Step 2: Add the wheels and spacers
Slide the spacers and the spinning wheels onto the Spinner Wheel Axle in the order shown in Diagram B. Align the spacers so that they will keep the spinning wheels equidistant apart. This assembly is now complete. (Diagram B)
The wheels and spacers go onto the Spinner Wheel Axle. Keep the spacers between the wheels so the spinning wheels sit apart from each other on the axle.
Tip: 5 O' Clock Somewhere, Flip Flops, Hummingbird, Monarch Butterfly, Patriotic, Peace, Pink Ladybug, Rainbow, Sun, Texas: the first two spacers are glued into place; slide the large wheel, two spacers, the medium wheel, another spacer, then loosen the screw in the “T” Joint on the back of the Circular Endpiece, slide the Endpiece all the way onto the axle, and tighten the screw. Go Team designs: first a spacer, then the large wheel, two spacers, the small wheel, one more spacer, and then the lock nut. The lock nut will serve as the end cap for the spinning wheel assembly. Monogram C/W, Game Fish, Maryland, Open, Rainbow Open, Air Force, Army, Navy: first a spacer, then the large wheel, two spacers, the medium wheel, another spacer, and finally the circular endpiece. This circular endpiece will serve as the end cap for the spinning wheel assembly.

Step 3: Set the spinner on the support pole
Drive Ground Stake into ground and insert non-ferruled end of Lower Support Pole into Ground Stake. Slide Spinner assembly onto the Lower Support Pole by inserting the ferruled-end of the Lower Support pole up into the vertical sleeve on the sail. Insert the lower end of the Upper Support Rod into this ferrule. (Diagram C)
The Ground Stake sits in the ground with the Lower Support Pole above it. The ferrule on the Lower Support Pole is below the sail, where the lower end of the Upper Support Rod fits into it.

Care and storage
Although your Garden Spinner is constructed with UV resistant SolarMax™ fabric, to preserve its durability, we recommend taking it inside during harsh weather or when not in use.
Products this guide covers
Monogram Triple Spinner - C
Monogram Triple Spinner - W
Triple Spinner - 5 O' Clock Somewhere
Triple Spinner - Air Force
Triple Spinner - Army
Triple Spinner - Blue
Triple Spinner - Blue/Gray
Triple Spinner - Blue/Red
Triple Spinner - Blue/Yellow
Triple Spinner - Flip Flops
Triple Spinner - Game Fish
Triple Spinner - Maroon
Triple Spinner - Maroon/Yellow
Triple Spinner - Maryland
Triple Spinner - Monarch Butterfly
Triple Spinner - Open
Triple Spinner - Orange
Triple Spinner - Patriotic
Triple Spinner - Peace
Triple Spinner - Pink Ladybug
Triple Spinner - Rainbow
Triple Spinner - Rainbow Open
Triple Spinner - Sun
Triple Spinner - Texas
Triple Spinner - Hummingbird
Triple Spinner - Navy
Download the original manuals
Premier prints a manual for each design; the steps are the same apart from the differences noted above.


Share:
Tricycle Spinner Assembly Instructions
24 in. Twin Wheel Spinner Assembly Instructions