This guide covers assembly for the Premier Wind Garden 24 in. Twin Wheel Spinner. It follows the manufacturer’s wheel, axle, support pole, and ground stake instructions.

Applies to: Triple Ring Spinner and Twin Wheel Spinner - 24 In. See the 2 products this guide covers.

Products covered

Product Spinner platform
Triple Ring Spinner Triple Ring
Twin Wheel Spinner - 24 In. Twin Wheel

Assembly

Step 1: Remove the string

Remove and discard string tying ends of Wheel Halves.

Twin Wheel Spinner diagrams showing wheel halves, axle hardware, support pole, and ground stake
Diagrams A-D: Wheel, axle, support pole, and ground stake assembly.

Step 2: Join the wheel halves

Join ends of Wheel Halves at ferrules to assemble Wheels. (diagram A)

The ferrules are the short sleeve pieces at the open ends of the Wheel Halves. When joined as shown, each completed Wheel forms a closed circle.

Step 3: Remove the end hardware

Remove Pin from one end of Wheel Axle and slide off Rubber Cap and first Stopper. (diagram B)

The Wheel Axle, Pin, Rubber Cap, and Stopper are labeled on the axle. On the shown end, the Pin lifts out, and the Rubber Cap and first Stopper slide off the end of the axle.

Step 4: Install the wheels on the axle

Slide one of the completed Wheels onto Wheel Axle up to second Stopper. Replace first Stopper and Rubber Cap on end of Wheel Axle and reinsert Pin. Repeat on other end of Wheel Axle using second Wheel. (Note: Wheels should spin in opposite directions) (diagram C)

The completed Wheel slides onto the Wheel Axle from the open end. After the first Stopper, Rubber Cap, and Pin are replaced, repeat the same arrangement on the other end of the Wheel Axle for the second Wheel.

Step 5: Set the stake and pole

Pound Ground Stake into ground and insert non-ferruled end of Support Pole into Ground Stake. Insert pole section of completed Twin Wheel into ferrule on top of Support Pole. If additional height is desired, use second Support Pole provided. (see diagram D)

The Ground Stake sits in the ground with the Support Pole standing upright in it. The pole section of the completed Twin Wheel points down into the ferrule at the top of the Support Pole.

Care and wind caution

CAUTION: To prolong life of Twin Wheel, never leave out in storms, bad weather, or in winds of over 20mph.

Products this guide covers

Download the original manual

24 in. Twin Wheel Spinner Assembly Instructions (PDF)

Latest Stories

This section doesn’t currently include any content. Add content to this section using the sidebar.