This guide covers assembly for Premier Whirly Wing Spinner bird and bug designs. It includes the wing and body assembly, support pole, ground stake, and care note.

Applies to: Blue Jay, Cardinal, Hummingbird, Macaw, Yellow Duck, Bee, Ladybug, and Dragonfly Whirly Wing Spinners. See the 8 products this guide covers.

Whirly Wing Spinner sizes

Designs Spinner platform Size (W x L)
Blue Jay, Cardinal, Hummingbird, Macaw Bird 19 in. x 13.5 in.
Yellow Duck Bird 18 in x 13.5 in.
Bee, Ladybug Bug 18 in x 13.5 in.
Dragonfly Bug 25.5 in. x 13.5 in.

Assembly

Step 1: Remove the cotter pin and washer

For Blue Jay, Cardinal, Hummingbird, Macaw, Yellow Duck, Bee, and Ladybug: Your Whirly Wing Spinner comes out of the package with the Body attached to the horizontal axle. Remove the Cotter Pin from the Body Ferrule and slide the Spinner Body and one Nylon Washer off of the horizontal axle. Remove the tie from the wings.

The horizontal axle runs through the wing area, with a Nylon Washer shown on each side of the wing assembly. After this step, the wings are untied. For Blue Jay, Cardinal, Hummingbird, Macaw, Yellow Duck, Bee, and Ladybug, the Spinner Body and one Nylon Washer are off the axle; for Dragonfly, one Nylon Washer is off the axle.

Tip: Dragonfly: Your Whirly Wing Spinner comes out of the package in three separate pieces. Remove the Cotter Pin from the Horizontal Axle and slide one Nylon Washer off of the horizontal axle. Remove the tie from the wings.

Whirly Wing Spinner assembled wing and body on horizontal axle with washers, cotter pin, and hub
Diagram A: Completed Spinner assembly with axle, washers, cotter pin, body ferrule, and star lock hub.

Step 2: Install the wings and body

Slide the wings onto the horizontal axle and replace the Nylon Washer and Body. Slide the Cotter Pin through the hole on the Body Ferrule and bend the ends outward to hold the Pin in place. Completed Spinner assembly should match Diagram A. Please note: The more sloped edge of the wing should go towards the front. Please see Diagram B.

In the completed assembly, a Nylon Washer sits on each side of the wing assembly on the horizontal axle. The Body Ferrule is on the side where the Cotter Pin goes back through, with the pin ends bent outward.

Whirly Wing Spinner wing shape with front and back labeled
Diagram B: Front and back of wing.

Step 3: Attach the support pole and stake

Slide the narrow end of Unferruled Support Pole into Star Lock Hub. Push the Support Pole until it locks into place and can not be removed. Drive Ground Stake into ground. Slide assembled Whirly Wing Spinner into Ground Stake. (Diagram C)

The arrows show the Support Pole going into the Star Lock Hub and the assembled Whirly Wing Spinner going into the Ground Stake. The Ground Stake sits in the ground with the Support Pole standing above it.

Whirly Wing Spinner with support pole, ferrule, and ground stake
Diagram C: Spinner, support pole, ferrule, and ground stake.

Care

It is recommended that you take your Whirly Wing Spinner inside during storms and harsh weather to preserve its durability.

Products this guide covers

Download the original manuals

Premier prints a manual for each design; the steps are the same apart from the differences noted above.

Latest Stories

This section doesn’t currently include any content. Add content to this section using the sidebar.