This guide covers assembly for Premier Windmill Spinners in the Calypso and Patriotic designs. Both designs use the same windmill spinner setup.
Applies to: Windmill Spinner - Calypso and Windmill Spinner - Patriotic. See the 2 products this guide covers.
Product specs
| Designs | Spinner Platform | Size (W x L) |
|---|---|---|
| Calypso; Patriotic | Windmill | 33 in. x 25 in. |
Assembly
Step 1: Assemble the sail
Slide the upper support rod attached to the hub into the vertical sleeve on the sail. Insert the sail strut into the sleeve opening and slide it all the way through the horizontal sleeve and into the Aluminum Ferrule. The sail assembly is now complete. (Diagram A)
The upper support rod goes into the vertical sleeve from below, with the hub at the top of the sail. The sail strut runs through the horizontal sleeve toward the Aluminum Ferrule.

Step 2: Complete the spinners
Complete the two Spinners by inserting the two unattached spokes of each Spinner into the two empty holes in each Blade Hub. (Spinners come with four of six Spokes pre-inserted and glued into holes.) (Diagram B)
Work on both spinners the same way. The “FRONT” label is at the center of the Blade Hub.

Step 3: Add the spinner wheels, spacers and end cap
Slide the Spinner Wheels, Spacers and End Cap onto the Front Horizontal Support Rod in the order shown above. Be sure to leave a small amount of space between each piece. (Diagram C)
The Large Spinner Wheel sits closest to the fixed stoppers, followed by the Plastic Spacer, the Small Spinner Wheel and the End Cap at the outside end. A small gap is visible between the pieces when they are spaced as shown.

Step 4: Install the support pole and ground stake
Drive Ground Stake into ground and insert non-ferruled end of Lower Support Pole into Ground Stake. Slide Spinner assembly onto the Lower Support Pole by inserting the ferruled-end of the Lower Support pole up into the vertical sleeve on the sail. Insert the lower end of the Upper Support Rod into this ferrule. If you desire extra height, add the extra ground shaft included in this package. (Diagram D)
The ferrule end of the Lower Support Pole is at the top in the installed view, with the non-ferruled end in the Ground Stake. The Spinner assembly sits above the Lower Support Pole with the vertical sleeve aligned over it.
Care note
Although your Windmill Spinner is constructed with UV resistant SunTex™ fabric, it is recommended that you take it inside during storms and harsh weather to preserve its durability.


Windmill Spinner - Calypso
Windmill Spinner - Patriotic
Share:
WindGarden Flying Spinner Assembly Instructions
Wolf NG Assembly Instructions